160TH ST., CLEVELAND, OHIO 44135 E.-U. • 800-251-0001 Mr. Heater et HeatStar sont des marques de commerce deposees de enerco Group, Inc. © 2003, enerco Group Inc. Tous droits reserves. ENERCO GROUP, INC., 4560 W. 160TH ST., CLEVELAND, OHIO 44135 • 800-251-0001 08/08 #50120 4000ID Serie Chauffage Portatif Indirect-tire NO. STOCk NO. DESCRIPTION 67 e30443 Cable avec fiche et presse cable 68 e11030 Lampe 230V 69 T20353 Gicleur 1,50 GPH 45° W 70 P10137 Tete broleur avec electrodes 71 e10254 electrod
Cylinder 20 Lb. Cylinder 1 1 1 2 2 2 Hi Med Lo Hi Med Lo 14,000 2,000 8,000 28,000 24,000 16,000 17 20 28 9 10 15 30 35 52 15 18 28 Figure 2 Mr. Heater | Gas-Fired Infra-Red Portable Heater 4 Operating Instructions and Owner’s Manual 2. 2. A. READ INSTRUCTIONS CAREFULLY: Read and adhere to these instructions. Do not allow anyone who has not read the instructions to assemble, light, adjust or operate the heater. WARNING KEEP THE HEATER OUT OF THE REACH OF CHILDREN B. PROPANE IS VERY FLAMMABLE: In
Do not allow anyone who has not read these instructions to assemble, light, adjust or operate the heater. GAS-FIRED INFRA-RED PORTABLE HEATER CYLINDER NOT INCLUDED MODEL MH12CS MODEL MH12C If the information in this manual is not followed exactly, a fire or explo- sion may result causing property damage, personal injury or loss of life. WARNING: — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — An LP cylinder not connected for
FOLLOW SHUTDOWN AND STORAGE INSTRUCTIONS TO TRANSPORT OR MOVE THIS APPLIANCE. Mr. Heater | Gas-Fired Infra-Red Portable Heater 4 Operating Instructions and Owner’s Manual 3. 3. A. WARNING: This heater is an unvented appliance and MUST be used ONLY in a well ventilated area. NEVER attempt to operate the heater inside any vehicle, camper or enclosure. B. Any combustion process requires and consumes oxygen, and will produce carbon monoxide. THIS HEATER MUST BE USED WITH ADEQUTATE VENTILATION. Do no
When the heater is working properly: * The flame is contained within the heater. * The flame is essentially blue with perhaps some yellow tipping. * There is no strong disagreeable odor, eye burning or other physical discomfort. * There is no smoke or soot internal or external to the heater. * There are no unplanned or unexplained shut downs of the heater. The parts lists and exploded view show the heater as it was constructed. Do not use a heater which is different from that shown. In this rega
B. Carefully screw POL nut directly into bulk propane cylinder, counterclockwise. REMEMBER – This is a left hand thread – see Figure 1. Make sure the heater is in a vertical upright position and directed away from the collar of the bulk tank. Use a 7/8” open end wrench to tighten the POL fitting – left hand thread – see Fig. 1. 6. LIGHTING INSTRUCTIONS A. Before attempting to light the heater, check all fittings and connections with a soap solution. NEVER USE A MATCH TO CHECK FOR LEAKS. Should a
2). You can also remove door into adjoining WARNING: If the area in which the heater may be operated in smaller that that defined as an unconfined space or if the building is of unusually tight construction, provide adequate combustion and ventilation air by on the methods described in the National Fuel Gas Code, NFPA 54/ ANSI Z223.1, Section 5.3 or applicable local codes. 3. Add the Btu/hr of all the fuel-burning appliances in the space such as, Vent–free heater, Gas water heater, Gas furnace,
IR20LPT BF20LPT IR30LPT BF30LPT 28-1 70361 — — — Orifice, 20, IR 3 28-2 — 70362 — — Orifice, 20, BF 1 29 70683 70683 70683 70683 Fan 1 30 70684 70684 70684 70684 Fan motor 1 31-1 70685 70685 70685 70685 Fan Mounting Bracket 2 31-2 70686 70686 70686 70686 Fan Venturi 1 31-3 70687 70687 70687 70687 Fan Cover 1 32 70688 70688 70688 70688 Fan switch 1 33-1 70672 70672 70672 70672 Fan air channel - Left 1 33-2 70673 70673 70673 70673 Fan air channel - Bottom 1 34 70674 70674 70674 70674 Digital Therm
Take apart gas tubing and remove foreign matter 2. Locate and correct all leaks (see Checking Gas Connections, page 8) 1. This is common with most heaters. If noise is excessive, contact qualified service person 1. Refer to Fresh Air of Combustion and Ventilation page 3 through 5. Heater produces unwanted odors. Heater shuts off in use (ODS operates) Gas odor even when control knob is in OFF position Gas odor during combustion Heater produces a cliking/ ticking noise just after butner is lit or
• Propane (LP) gas odor may differ in intensity at different levels. Since Propane (LP) gas is heavier than air, there may be more odor at lower levels. • Always be sensitive to the slightest gas odor. If you continue to detect any gas odor, no matter how small, treat it as a serious leak. Immediately go into action as discussed previously. ATTENTION - CRITICAL POINTS TO REMEMBER! • Propane (LP) gas has a distinctive odor. Learn to recognize these odors. (Reference Fuel Gas Odor and Odor Fading