Improper use of generator can cause serious injury. Keep this manual for future reference. ® ® PORTABLE GASOLINE GENERATORS SAFETY INFORMATION WARNINGS IMPORTANT: Read this owner’s manual and the engine owner’s manual carefully. Become familiar with this generator before trying to operate or service it. Know its uses, limitations, and any hazards involved. Improper use of generator can cause severe injury or death from explosion, fire, burns, electrical shock, or carbon monoxide poisoning. DANGE

It also powers the 120V receptacles at reduced wattage capacity. IMPORTANT: Do not move the full power selector switch while powering electrical items.Unplugallitemsbeforemovingswitch. Failure to do so can damage switch. Models HWI3000A,MGH3000GA,MGH3000A,and MGH6500AIE do not have this switch. These models provide full power to all receptacles. 120 VOLT ONLY 120/240 VOLT Position Position Figure 3 - Full Power Selector Switch AUTO-IDLE SYSTEM TheAuto-IdleSystemallowstheenginetoidle down or run

This can cause fire or explosion. After refueling, tightly close fuel tank cap. • Do not spill fuel. Fuel or fuel vapor may ignite. If fuel spills, make sure area is dry before starting engine. • Never smoke in refueling area. Never allow open flames or sparks in area. • Store fuel in approved container. Store fuel in a well- vented area free of open flames or sparks. Use clean, fresh, unleaded gasoline. Use gasoline with octane rating of 86 or higher. Service station gasoline pumps should displ

Must purchase Alternator Assembly. 104960 19 20 104960 PORTABLE GASOLINE GENERATORS ® ILLUSTRATED PARTS LIST FOR MODEL RGH11000IE ALTERNATOR ASSEMBLY This list contains replaceable parts used in your generator. When ordering parts, follow the instructions listed under Replacement Parts on page 17 of this manual. 1 Stator * 1 2 Rotor * 1 3 Draw Bolt 103188-01 1 4 Fan 103191-01 1 5 Balancing Disc 103192-01 1 6 Lifting Eyes 103193-01 2 7 D.E. Bracket 103194-01 1 8 N.D.E. Bracket 103195-01 1 9 Mount

6. Never connect generator to any existing electrical circuits. The generator output will back-feed into the utility power line. This may electrocute a power company line repair person. Also, if generator is powering electrical circuits, the chance of an electrical fire exists. 7. Battery gives off explosive gases. Keep sparks, flames, and cigarettes away. Do not remove or install battery cables when engine is cranking or running. Only service or use battery in a well- vented area. 8. Battery co

When ordering parts, follow the instructions listed under Replacement Parts on page 17 of this manual. KEY NO. PART NUMBER DESCRIPTION QTY. 1 25954000 Gas Cap/Fuel Gage 1 2 099832-01 Gas Tank (with 90° fitting) 1 3 25978000 Breather Assembly 1 4 M51043-01 Screw, 1/4-20 x 1" 4 5 099701-01 Screw, M5 x 10 1 6 19508001 Gas Line Clamp 2 7 25985005 Fuel Line 1 8 099743-01 Fuel Filter 1 9 099752-01 Roll Cage† 1 099752-02 Roll Cage. 1 10 103880-01 Lock Nut, 1/4-20 5 11 NEC-5C Lock Nut, 5/16-18 8 12 1413

Note:When this happens, the engine switch remains in the ON position. The oil alert system is wired into the ON/OFF Switch. If this system shuts down the engine, the engine will not start until you add oil. Add oil to engine (see Engine Oil, page 7). Note:Operate generator on a level surface. If not level, the oil may flow away from the oil level sensing device. This will cause the oil alert system to shut down engine. See engine owner’s manual for more information. ENGINE SWON OFF Models RGH300

Models RGH3000 and RGH3000PR have only the 120V, 15-amp GFCI duplex receptacle. 120V, 15-Amp GFCI Duplex RESET 240 VOLTSRESET RESET RESET RESETTEST 120 VOLTS RESET RESET ENM00000005HOURS 1/10 120ONLY 120240V 120/240V, 20 or 30- Amp Twist-Lock 120V, 30-Amp Twist-Lock 120V, 15-Amp Duplex 120/240V, 50-Amp (Model RGH11000IE only) Figure 15 - Receptacle Locations POWER CORD AND PLUG REQUIREMENTS 120V, 30-amp twist-lock receptacle • NEMA L5-30P plug • Three-wire, 30-amp cord 120/240V, 20 or 30-amp twi

Keep generator clean. Use a damp cloth to clean outside surfaces. Never use water to clean generator. Water can cause damage to internal parts. Use vacuum to clean air inlet and outlet louvers of alternator. STORAGE WARNING: Remove all fuel from fuel tank before storing generator. Store fuel in approved container. Store fuel in a well-vented area free of open flames or sparks. WARNING: The muffler becomes very hot during operation. The muffler remains hot for a while after shutdown. Let engine c

Only use grounded plugs with generator. Only use grounded extension cords. Only use three- wire or double-insulated power tools. Grounding generator helps prevent electric shock from a ground fault condition. Locate ground lug on end of generator housing (see Figure 13). Attach a #10 stranded-copper ground wire to ground lug. Drive grounding point into ground. Grounding point can be a stake, grounding rod, or pipe. Grounding point should be copper or brass. Attach ground wire to grounding point.