Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
3 Fully open the door. If the doo_ will not hilly open, the indentation is not seated correctly in the bottom edge of the slot. 4 Push the hinge locks up against the front fl'ame of the oven cavity, to the locked position. 5 (;lose the oven door. Slot d_b Hinge lock Pull hinge locks down to unlock Bottom earm edgeof Indentation Hinge..._/! lock //I Push hinge locks up to lock _PYobg The temperature probe may be cleaned with soap and water or a soap-filled scouring pad. Cool the teml)eramre probe beflwe cleaning. Scour stubborn spots with a soap-filled scom'ing pad, rinse and dry. Do not imme*se the tempemtu*v probe in ware*: Do not sto*v the temp(,rature probe in the oven. (;are and (;leaning 1.19111Ov._ Overzlights Each oven is equipped with two halogen light assemblies h)cated on tile side _dls of tile o\en. Tile lights come on when tile door is opened or when tile oven is ill a cooldng cycle. Tile oxen lights do not come on during self:cleaning or if tile Sabbath Feature is set. Each light assembly consists of a rein (_vable light cover with two locking clips, a light compartment with three light bulb sockets and three halogen light bulbs. CAUTION: Befiwe rei)lacino_ tile bulb, discomlect electrical po*_er to tile oxen at tile main fuse or circuit breaker panel. Be sure to let tile light cover and bulb cool completel}. For )our safety, do not touch a hot btdb with bare hands or a damp cloth. To remove: Remoxe tile racks from tile oxen. See tile Fidl (!XtFILSlOII O'gl('ll Ya( /.5 sectioll. Using an a(!justable wrench, remove tile fi)ur nuts homing the rack suppm_ over tile light assembly. Remove tile glass light cover b} pulling its back edge ()sit and rolling it to* and completely cool. Replace tile rack suppoxl with tile slotted holes over tile rear bolts and tile round holes over tile fl'ont bolts. I,ightly secure with tile fimr nuts removed earliei; but do not eyed tighten or tile enamel could be chipped. Slotted Round boles holes over over rear front bolts bolts Replace tile racks. See tile Fidl extension O*Ug?/ rac/._ssection. Recomlect electrical power to tile oxen. Care and Cleaning Wall Ov_,_ 7b clean the door Stainless steel su #ces (on some models) Painted s_tgrfaces (on so_z€ modeS) Inside of the door: * Because the area inside the gasket is cleaned during the self'clean cycle, you do not need to clean this by hand. Any soap left on the liner causes additional stains when the oven is heated, so be sure to vh_se thoroughly. * The area outside the gasket can be cleaned with a soap-filled scouring pad. " Do not rub or clean the door gasket-the fiberglass material of the gasket has an extremely low resistance to abrasion. An intact and well-fitting oven door gasket is essential fl)r energDetticient oven operation and good baking results. If wm notice the gasket becoming worn, fl'ayed or damaged in any way or if it has become displaced on the oven, you should have it replaced. Outside of the door: '_ Del)ending, on }(mr model, see the 5"tainle,s,s ,steel ,slff_?l_ e,s section or the Pai_ted ,slff_h_ e,s section. Do not use a steel-wool pad; it will scratch the surface. To clean the stainless steel surfitce, use warm sudsy water or a stainless steel cleaner or polish. _Mways wipe the surfime in the direction of the grain. Follow the cleaner ...
Эта инструкция также подходит к моделям:Электрические печи - ZET2 (2.87 mb)
Электрические печи - ZET1 (2.87 mb)
Электрические печи - ZET1 (2.87 mb)