Оценок - 6, средний балл: 3.8 ( )

Производитель: Bertazzoni Размер: 2.72 mb Название файла: Язык инструкции:

To convert the regulator for use with other liquid propane LP gas: 1. Unscrew by hand the upper cap of the regulator, remove the white plastic attachment from the cap, reverse its direction and screw it again firmly against the cap. The white plastic attachment has arrows indicating the position for natural gas (NAT) and LP gas (LP). 2. Screw by hand the metal cap in the original position on the regulator. 19 STEP 2: SURFACE BURNERS To replace the nozzles of the surface burners, lift up the burners and unscrew the nozzles shipped with the range using a 7 mm {socket wrench). Replace nozzles using the conversion set supplied with the range or by a Bertazzoni authorized parts warehouse. Each nozzle has a number indicating its flow diameter printed on the body. STEP 3: MINIMUM FLAME ADJUSTMENT WARNING! These adjustments should be made only for use of the appliance with natural gas. For use with liquid propane gas, the choke screw must be fully turned in a clockwise direction. SURFACE BURNERS 1. Light one burner at a time and set the knob to the MINIMUM position (small flame). 2. Remove the knob. 3. The range is equipped with a safety valve. Using a small.size slotted screwdriver, locate the choke valve on the valve body and turn the choke screw to the right or left until the burner flame is adjusted to desired minimum. 4. Make sure that the flame does not go out when switching quickly from the MAXIMUM to the MINIMUM position. Consult the table on page 20 for matching nozzles to burners. 20 GAS BURNERS DATA TABLES Models X304PIRX [M7S0PTU(4,6)X(2,5)D] Models X304PIRBI [M7S0PTU(4,6)W(2,5)D] Models X304PIRCR [M7S0PTU(4,6)D(2,5)D] Models X304PIRGI [M7S0PTU(4,6)I(2,5)D] Models X304PIRRO [M7S0PTU(4,6)R(2,5)D] Models X304PIRVI [M7S0PTU(4,6)L(2,5)D] Models X304PIRVE [M7S0PTU(4,6)V(2,5)D] Models X304PIRBL [M7S0PTU(4,6)U(2,5)D] Models X304PIRNE [M7S0PTU(4,6)N(2,5)D] Burner Position Injector Gas Pressure Max Rate Min Rate By.pass diam. [mm.] Type [i.w.c.] [BTU/h] [W] [BTU/h] [W] diam. [mm] Auxiliary Rear L 0,90 NG 4” 3400 996 900 264 Regulated 0,54 LP (Propane) 11” 3400 996 900 264 0,29 Semi.Rapid Front R 1,18 NG 4” 6100 1787 1500 439 Regulated 0,70 LP (Propane) 11” 6100 1787 1500 439 0,36 Rapid Rear R 1,55 NG 4” 10400 3047 2500 732 Regulated 0,92 LP (Propane) 11” 10400 3047 2500 732 0,47 Dual Burner Front L Inner 0,80 NG 4” 2800 820 900 264 Regulated 0,49 LP (Propane) 11” 2800 820 900 264 0,29 Front L Outer N°2 x 1,15 NG 4” 12000 3516 4500 1318 Regulated N°2 x 0,70 LP (Propane) 11” 12000 3516 4500 1318 0,65 21 INSTALLATION Checklist FINAL PREPARATION 1. Is the range mounted on its legs? 2. Is the back guard securely connected? 3. Has the anti.tip device been properly installed? 4. Does the clearance from the side cabinets comply with the manufacturers directions? 5. Is the electricity properly grounded? 6. Is the gas service line connected following the directions of the manufacturer? 7. Have all the proper valves, stoppers and gasket been installed between the range and the service line? 8. Has the gas connection been checked for leaks? 9. Has the range been set for the type of gas available in the household? 10. Does the flame appear sharp blue, with no yellow tipping, shooting or flame lifting? 11. Has the minimum setting for all burners been adjusted? All stainless steel body parts should be wiped with hot, soapy water and with a liquid stainless steel cleanser. If build.up occurs, do not use steel wool, abrasive cloths, cleaners, or powders! If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to loosen the material, then use a wood or nylon scraper. Do not use a metal knife, spatula, or any other metal tool to scrape stainless steel! Scratches are almost impossible to remove. Before using the oven for food preparation, wash the cavity thoroughly with a warm soap and water solution to remove film residues and any dust or debris from installation, then rinse and wiped dry. 22 USER MANUAL WARNING! Proper Installation. Be sure your appliance is properly installed and grounded by a qualified technician. Do not leave children alone. Children should not be left alone or unattended in area where appliance is in use. They should never be allowed to sit or stand on any part of the appliance. Wear proper apparel. Loose.fitting or hanging garments should never be worn while using the appliance. User servicing. Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be referred to a qualified technician. Use only dry potholders. Moist or damp potholders on hot surfaces may result in burns from steam. Do not let potholder touch hot heating elements. Do not use a towel or other bulky cloth. Do not to cover the holes inside the oven with aluminium foil. Do not to cover the worktop with aluminium foil. Do not store any flammable object or objects under pressure in the storage compartment. Keep the area of operation ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: