• CARB compliant • Designed for class 5, 6, 7 and 8 trucks on short-haul routes • 7,000-BTU capacity – designed for 2-hour runtime on batteries • Battery powered • Zero fuel consumption • No moving parts – low maintenance • Compact compressor/evaporator unit fits between seats • Patented split-system design with flexible refrigerant linesets and reusable quick- connect fittings • No special tools for installation • Designed for the harshest over-the-road conditions • Backed by factory engineerin

Roof Preparation 1. Opening Requirements - Before preparing the ceiling opening, read all of the following instructions before beginning the installation. If a roof vent opening will not be used a 14-1/4" x 141/ 4" (±1/8") opening must be cut through the roof and ceiling of the RV. This opening must be located between the roof reinforcing members. There may be electrical wiring between the roof and the ceiling. Disconnect 120 volt AC power cord and the positive (+) 12 volt DC terminal at the sup

See FIG. 15. FIG. 15 THERMOSTAT WARM COOL Note: The thermostat does not control the unit optional electric heater if installed. B. Cooling Operation 1. Set the thermostat at the desired temperature level. 2. Select the fan speed that best satisfies your needs: a. HIGH COOL: Selected when maximum cooling and dehumidification required. b. MED COOL: Selected when normal or average cooling required. c. LOW COOL: Selected when room at desired comfort level and needs to be maintained. Normally this sp

1. Remove the air conditioner from the carton and discard carton. See FIG. 7. FIG. 7 2. Place the air conditioner on the roof. 3. Lift and place the unit over the prepared opening using the gasket on the unit as a guide. See FIG. 8. FIG. 8 FRONT CAUTION Do not slide the unit. This may damage the roof gasket attached to the bottom and may create a leaky installation. 6 4. Place the 3105457 Mechanical Air Distribution Box Kit inside the RV. This box contains mounting hardware for the air condition

Modification of this product can be extremely hazardous and could result in personal injury or property damage. Lire et comprendre ce manuel avant de proceder a l'installation, a des reglages, de l'entretien ou des reparations. L'installation de cet appareil doit etre effectuee par un reparateur qualifie. Toute modification de cet appareil peut etre extremement dangereuse et entrainer des blessures ou dommages materiels. MODEL 630025.331 Roof-Top Heat Pump used with 3106152.006 Mechanical Air Di

2. Don’t touch electrical switches. 1. Ouvrez les fenetres. 2. Ne touchez a aucun interrupteur. 3. Eteignez toute flamme nue. 3. Extinguish any open flame. 4. Avertissez immediatement votre fournis4. Immediately call your gas supplier. seur de gaz. FOR YOUR SAFETY Pour votre securite Do not store or use gasoline or other Ne pas entreposer ni utiliser de l’essence ni d’autres vapeurs ou liquides inflammables aflammable vapors and liquids in the proximite de cet appareil ou de tout autre vicinity

Service Offic. The Dometic Corp. 509 South Poplar St. LaGrange, IN 4676. CANAD. Dometic Dist. 866 Langs Dr. Cambridge, Ontari. CANADA N3H 2N. Catalina 2500 INSTALLATION & OPERATING INSTRUCTIONS REVISIO. Form No. 3103624.023 3/98 (Replaces 3103624.015) (French 3108310.024) ©1998 The Dometic Corporatio. LaGrange, IN 4676. A&E CATALINA 250. A&E CATALINA 250. INSTALLATION/OPERATIO. APPLICATIO. The A&E Catalina 2500 Case Awning is designed an. intended for direct mounting on straight and most curve.

Parking the RV in a shaded area 2. Using window shades (blinds and/or curtains) 3. Keeping windows and doors shut or minimizing us age 4. Avoiding the use of heat producing appliances Operation on High Fan/Cooling mode will give optimum or maximum efficiency in high humidity or high outside temperatures. Starting the air conditioner early in the morning and giving it a "head start" on the expected high outdoor ambient will greatly improve its ability to maintain the desired indoor temperature. F

Refer to Operating Manual or Users Guide for a description of the air conditioner operation. Micro-ThermFilterSystemMicro-Therm Filter System CLEAN Return Air Cover FIG. 25 Grill Foam Divider Ceiling Template Slider Filter Handle Genesis Air Filtration System Return Air Kit 1. Install the slider in the return air cover and raise it to the ceiling template. Route the filter indicator wires from the return air cover through the template slot leaving about 3” between. Place the front of the return

d. Return air openings must have 40 square inches minimum free area including the filter. e. Return air to the air conditioner must be filtered to prevent dirt accumulation on air conditioner cooling surface. 5. Air Distribution System Installation a. Dometic Corporation recommends the basic configuration shown on page 7, for installing this air conditioner system. We have found by testing, that this configuration works best in most applications of this air conditioner system. It is the responsi