¦ If you select “Temperature”, the display will alternate between the set temperature (steady light) and the actual temperature (flashing light). ¦ When the oven is in its programmed cooking cycle, you may modify the Time parameter (add minutes) while the program is in progress. • START / STOP COOKING CYCLE ¦ To start or stop the cooking cycle, press the START / STOP key. ¦ At the end of the cooking cycle, the heating element(s) and fan(s) will stop running and a tone will sound for 15 seconds.

4 Fig. 5 With door completely down and door safety lock in its down position, move door in a closing direction until door safety lock stops the closing action as in Fig. 5. ~~~~~~~~ Hold door as shown in Fig. 6. Fig. 6 Fig. 7 Slightly lift and swing door out of unit as shown in Figs. 7 & 8 Fig. 8 Fig. 9 For the door to be properly installed, the notch on the bottom of the hinge finger (Fig. 9) must be seated in the inner door hinge frame (Fig. 10) Fig. 10 Reverse above procedure to attach door t

Save the program by pressing the Memory key (for about 5 seconds) until you hear a tone. When the tone is heard, the program is saved, and the program number will appear in the display window. 6. You may press the P key to go back into the manual mode at any time. 7. To start the program, press the START/STOP key. • TO RECALL A PROGRAM ALREADY IN MEMORY: 1. Press the P key. The display will read “P01”. 2. Select the number of the program you wish to use by pressing the or key (the program number

The display window will read “0.00” (this shows the time in hours and minutes). ¦ 15 minutes after a preset program ends or the cooking time expires, the light inside the cooking chamber will automatically shut off. The display and lights will be off, except for the red START / STOP light. To switch on the control panel, simply press the START / STOP key. • SELECT KEY The SELECT key allows the operator to select and set two functions: TIME and TEMPERATURE. • TIME ¦ To choose the Time function, p

6 Automatic Preheat in Programmed Mode........................................................................... 6 3.2 - Use of “Dynamic” Control Panel ....................................................................................... 7 Manual Mode ...................................................................................................................... 7 Programmed Mode.............................................................................................................

Be sure to remove any residual glue left on the outside of the oven with an appropriate solvent. 4. INSTALLATION 4.1 ELECTRICAL CONNECTION • Connection to the electrical power source must be done according to all state and local codes. Before connecting your oven, make sure that the voltage and the amps comply with those stated on the data plate of your oven. Avoid using patch cords and multiple jacks. • The appliance must be placed so that the connection plug to the outlet can be easily reached

2. SPECIAL MAINTENANCE • All maintenance operations must be done only by trained qualified personnel. • Before starting any maintenance operation, disconnect your oven from the electrical power supply and wait for it to cool down. 2.1 REPLACEMENT OF INTERNAL LAMP To replace the internal lamp: • Disconnect your oven from the power supply system and let it cool down. • Remove the side rails. • Unscrew the glass cover and replace the lamp with an identical bulb. • Screw the glass cover back on. • R