Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
11). the screw will not properly seat. setting adjustment collar that may be adjusted to one of forty-four settings. Correct. Head of screw is below surface, but does not puncture fac-ing. Too deep. Head of screw punches hole in drywall surface, making finishing difficult and allowing moisture be-neath facing. Decrease depth. Too shallow. Head of screw extends above drywall face and can not be finished off. Increase depth. Fig. 11 The snap-action clutch will automatically The torque is adjustable from 10 to 140 disengage and the insert bit will stop inch-pounds. rotating once the screw has been driven to the selected depth. The 6581-20 Screwdriver has a torque setting adjustment collar that may be These screwdrivers feature a snap-acadjusted to one of thirty-three settings. tion clutch, which may ratchet slightly Beyond setting thirty-three, the tool will stall when the screw is sunk to the selected before slipping the clutch. The torque is ad- depth. justable from 10 to 110 inch-pounds. NOTE: Practice driving screws into To select a setting, turn the adjustment pieces of scrap material to become collar in the direction indicated on the tool. familiar with the tool and the snap- The selected setting will appear in the action clutch action before attempting to window as shown (Fig. 9). drive screws into the workpiece. 3. To remove screws, remove the locator assembly and switch the forward/ reverse switch to the reverse position. Reattaching the locator assembly will not change the depth setting. 10 11 Fig. 10 NOTE: Use a piece of scrap material to test the different settings before driving screws into workpiece. To determine a specific setting for your application, use a torque wrench to check the correct torque at any particular setting. HIGHER -TORQUE - LOWER SETTING Fig. 9 NOTE: Use a piece of scrap material to test the different settings before driving screws into workpiece. To determine a specific setting for your application, torque wrench to check at any particular setting. Driving Decking Screws (Fig. 12)For Screwdrivers with Depth LocatorsRated 0-2500 RPM Standard decking screws are generally designed for attaching wood to wood studs. MILWAUKEE Screwdrivers are ideal for driving these types of decking screws. The depth setting is very important. Refer to the guide below for the correct depth setting (Fig. 12). Correct. Head of screw is below surface. Too deep. Head of screw punches hole in surface, allowing moisture to collect. Decrease depth. Too shallow. Head of screw extends above surface. Increase depth. Fig. 12 1. Select the proper decking screw for each job. Pilot holes are not needed. To insert screws, place the screw onto the insert bit, then align the screw against the work surface, making sure to hold the tool and screw square to the work surface. If the tool or screw are misaligned, the screw will not drive into the work surface or it will not drive straight. Wood screws have sharp points or drill points, and course threads tha...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - 6580-20 (414.82 kb)
Дрели и шуропопверты - 6581-20 (414.82 kb)
Дрели и шуропопверты - 6792-20 (414.82 kb)
Дрели и шуропопверты - 6702-20 (414.82 kb)