Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
MILWAUKEE Screwdrivers are ideal for driving these types of decking screws. The depth setting is very important. Refer to the guide below for the correct depth setting (Fig. 12). Correct. Head of screw is below surface. Too deep. Head of screw punches hole in surface, allowing moisture to collect. Decrease depth. Too shallow. Head of screw extends above surface. Increase depth. Fig. 12 1. Select the proper decking screw for each job. Pilot holes are not needed. To insert screws, place the screw onto the insert bit, then align the screw against the work surface, making sure to hold the tool and screw square to the work surface. If the tool or screw are misaligned, the screw will not drive into the work surface or it will not drive straight. Wood screws have sharp points or drill points, and course threads that help the screw through the wood. 2. Pull the trigger and push the tool forward to sink the screw into the wood. A quick motion will engage the snap-action clutch, cause the screw to start rotating, sink the screw and disengage the snap-action clutch within a fraction of a second. If pressure is not maintained on the tool after engaging the snap-action clutch, the screw will not properly seat. The snap-action clutch will automatically disengage and the insert bit will stop rotating once the screw has been driven to the selected depth. These screwdrivers feature a snap-action clutch, which may ratchet slightly when the screw is sunk to the selected depth. NOTE: Practice driving screws into pieces of scrap material to become familiar with the tool and the snap-action clutch action before attempting to drive screws into the workpiece. 3. To remove screws, remove the locator assembly and switch the forward/ reverse switch to the reverse position. Reattaching the locator assembly will not change the depth setting. Driving Self-Drilling Screws intoCold-Formed Steel Framing (Fig. 13)For Adjustable Torque ScrewdriversRated 0-2500 RPM Follow this procedure when working with light gauge sheet metal, 20 gauge and thicker. The screw may hesitate slightly when it finishes breaking through the first layer of material and starts to penetrate the sheet metal. This is normal. Keep fi rm pressure on the tool until the screw is fully seated. Self-drilling and self-tapping screws drill, tap and fasten in one quick, easy motion without a separate drilling operation. Their unique design works in metal up to 1/2" thick, giving a strong, reliable hold. The drill point ensures rapid drilling and consistently low drilling pressure while the drill flutes remove drilling chips. The pilot section ensures that drilling is completed before the first thread engages the material. These screws can be used in many applications as shown at the right. Fig. 13 Corrugated siding Wood to structure Structure to structure Sheet to sheet Sheet to structure 12 13 1. Insert screw into the hex socket and align the screw against the work surface. 2. Pull the trigger while pushing the tool...
Эта инструкция также подходит к моделям:Дрели и шуропопверты - 6580-20 (414.82 kb)
Дрели и шуропопверты - 6792-20 (414.82 kb)
Дрели и шуропопверты - 6702-20 (414.82 kb)
Дрели и шуропопверты - 6703-20 (414.82 kb)