Оценок - 4, средний балл: 3.3
(
)
)
|
Фрагмент инструкции
2. Loosely fit console against headliner. Check that console is centered in vehicle and matches all contours of headliner. While supporting console in mounting position, loosely install using two (2) 6-32 X 3/4" screws (item 5 pg 2) through the smaller holes in bracket on console into threaded clips on mounting bracket. Inspect wiring to make sure no chaffing has occurred near the rear bracket (Item 3). 3. Secure front of console using one ( 1 ) # 8 X 1 1/2" PWH screw (item 7) in front pocket of OEM secondary pod and light assembly. See Figure 17. 4. Install one ( 1 ) # 6 x 1 1/4" PWH screw (item 6 pg 2) in dimple area at front of console through front mounting bracket. See Fig. 17. 5. Tighten 6-32 X 3/4" screws previously installed in step 2. Figure 17 Figure 19 10 6. Release video screen from locked position. Lower video screen to viewing position for access to mounting locations in top of video system housing. 7. Raise video system into approximate position and connect all wiring to components. Route video cable through hole in mounting bracket. Connect wiring and cabling to video system per instructions included with video system. 8. Check function of all components and lights. See operating instructions for video system operations check. For further assistance, refer to the video system manual for the technical support phone number listed for your area. 9. Insert video system into opening in console. Note: Make sure that wires do not get pinched between bosses on video system and console. Align holes in housing with threaded clips in mounting bracket. Loosely install four (4) 6-32 X 3/4" screws (item 5 pg 2) and four (4) 3.5 mm washers (item 9 pg 2). Caution: Do not overtighten screws. See Figure 18. 10. Raise video screen into locked position. Figure 18 11. Install two (2 ) # 8 x 1 3/4" POH screws (item 8 pg 2) and two (2) # 8 finish washers (item 10 pg 2) in dimples at rear of overhead console to secure rear of console to plywood support installed above headliner. See Figure 19. Do not overtighten screws. 11 CUT ON DOTTED LINES 12 ...
Эта инструкция также подходит к моделям:Автомобильное видео - 1181280 (1.54 mb)
Автомобильное видео - 1181280 (1.54 mb)
Автомобильное видео - 1181281 (1.54 mb)