Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
- The Sonicare toothbrush complies with
Note: To keep the battery fully charged at all times,
The Easy-start feature gently increases the power
Replacement
the safety standards for electromagnetic
you may keep your Sonicare on the charger when not
over the first 14 brushings.
devices. If you have a pacemaker or other
in use. It takes at least 24 hours to fully charge the
Brush head
implanted device, contact your physician or
battery.
Note: Each of the first 14 brushings must be at least
Replace Sonicare brush heads every 3 months for
the manufacturer of the implanted device prior
1 minute in length to advance through the Easy-start
optimal results.
to use.
Using the appliance
ramp-up cycle properly.
- This appliance has only been designed for
1 Wet the bristles and apply a small amount of
Deactivating and activating the Easy-
Environment
cleaning teeth, gums and tongue. Do not use it
toothpaste.
start feature
- Do not throw away the appliance with the
for any other purpose. Stop using the appliance
normal household waste at the end of its life,
and contact your doctor if you experience any
2 Place the toothbrush bristles against
1 Attach the brush head to the handle.
but hand it in at an official collection point for
discomfort or pain.
the teeth at a slight angle towards the
2 Place the handle in the plugged-in charger.
recycling. By doing this, you help to preserve
- Do not use other brush heads than the ones
gumline (Fig. 4).
- To deactivate Easy-start:
the environment (Fig. 10).
recommended by the manufacturer.
3 Press the power on/off button to switch on
Press and hold the power on/off button for 2
- The built-in rechargeable battery contains
- If your toothpaste contains peroxide, baking
the Sonicare.
seconds. You hear 1 beep to indicate that the Easy-
substances that may pollute the environment.
soda or other bicarbonate (common in
start feature has been deactivated.
Always remove the battery before you
whitening toothpastes), thoroughly clean the
4 Apply light pressure to maximise Sonicare’s
- To activate Easy-start:
discard and hand in the appliance at an official
brush head and the handle with soap and
effectiveness and let the Sonicare toothbrush
Press and hold the power on/off button for 2
collection point. Dispose of the battery at an
water after each use. Otherwise the plastic
do the brushing for you. Do not scrub.
seconds. You hear 2 beeps to indicate that the
official collection point for batteries. If you have
may crack.
5 Gently move the brush head slowly across
Easy-start feature has been activated.
trouble removing the battery, you can also take
Electromagnetic fields (EMF)
the teeth in a small back and forth motion
the appliance to a Philips service centre. The
so the longer bristles reach between your
Note: Using the Easy-start feature beyond the initial
staff of this centre will remove the battery for
This Philips appliance complies with all standards
teeth. Continue this motion throughout the
ramp-up period is not recommended and reduces
you and will dispose of it in an environmentally
regarding electromagnetic fields (EMF). If handled
brushing cycle.
Sonicare’s effectiveness in removing plaque.
safe way (Fig. 11).
properly and according to the instructions in this
Smartimer
user manual, the appliance is safe to use based on
Note: To make sure you brush evenly throughout the
Removing the rechargeable battery
scientific evidence available today.
mouth, divide your mouth into 4 sections using the
After 2 minutes, the Smartimer automatically
Quadpacer feature (see chapter ‘Features’).
switches off the toothbrush.
Please note that this process is not reversible.
General description (Fig. 1)
6 Brush each section for 30 seconds for a total
To pause or stop brushing during the 2-minute
To remove the rechargeable battery, you need a
A Replaceable Sonicare brush head
brushing time of 2 minutes. Start with section
cycle, press the on/off button. If you press the on/
flat-head (standard) screwdriver. Observe basic
B Battery charge indicator (specific types only)
1 (outside top teeth) and then brush section
off button again within 30 seconds, the Smartimer
safety precautions when you follow the procedure
C Power on/off button
2 (inside top teeth). Continue with section
picks up where you left off.
outlined below. Be sure to protect your eyes,
D Handle
3 (outside bottom teeth) and finally brush
Quadpacer
hands, fingers, and the surface on which you work.
E Charger
section 4 (inside bottom teeth). (Fig. 5)
The Quadpacer is an interval timer. At 30, 60 and
1 To deplete the rechargeable battery of any
Preparing for use
7 After you have completed the 2-minute
90 seconds, you hear a short beep and pause in
charge, remove the handle from the charger,
Attaching the brush head
brushing cycle, you can spend additional
the brushing action. This is your signal to move to
switch on the Sonicare and let it run until
time brushing the chewing surfaces of your
the next section of your mouth.
it stops. Repeat this step until you can no
1 Align the front of the brush head with the
teeth and areas where staining occurs.
longer switch on the Sonicare.
Cleaning
front of the toothbrush handle.
You may also brush your tongue, with the
toothbrush switched on or off, as you
Do not place brush head, the handle and the
2 Insert a screwdriver into the slot in
2 Push the brush head onto the metal
prefer (Fig. 6).
charger in the dishwasher.
the bottom of the handle and
shaft (Fig. 2).
turn counterclockwise to release the bottom
1 Rinse the brush head and bristles after each
cap (Fig. 12).
Note: There is a small gap between the brush head
The Sonicare is safe to use on:
use. Let the brush head air-dry only (Fig. 7).
and the handle.
- Braces (brush heads wear out sooner when
3 Hold the handle upside down and push
used on braces)
2 Remove the brush head once a week and
down on the shaft to release the internal
Charging the appliance
- Dental restorations (fillings, crowns, veneers)
clean the connection between the brush head
components of the handle (Fig. 13).
and the handle (Fig. 8).
1 Put the plug of the charger in the wall socket.
Note: When the Sonicare is used in clinical studies,
4 Insert the screwdriver under the circuit
the handle should be fully charged. Deactivate
Do not use sharp objects to press on the rubber
board, next to the battery connections, and
2 Place the handle on the charger.
the Easy-start feature and for areas where excess
seal, as this may cause damage.
twist to break the connections. Remove the
- The battery charge indicator shows the
staining occurs, an additional 30 seconds of brushing
circuit board and pry the battery from the
approximate remaining battery charge (Fig. 3).
time can be spent to assist with stain removal.
3 Clean the rest of the handle periodically with
plastic carrier (Fig. 14).
- Solid green light: 91-100%
mild soap and a moist cloth (Fig. 9).
- Flashing green light: 0-90%
Features
4 Unplug the charger before you clean it. Use
Guarantee and service
- Flashing green light and 3 beeps after the
Easy-start
a damp cloth to wipe the surface of the
If you need service or information or if you have
brushing cycle: less than 5% and toothbrush
charger.
a problem, please visit the Philips website at
has to be recharged.
This Sonicare model comes with the Easy-start
feature activated.
www.philips.com or contact the Philips
...Эта инструкция также подходит к моделям:
Зубные щетки - HX6511/34 (240.08 kb)
Зубные щетки - HX6511/50 (240.08 kb)