Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
• Do not set the device up where it is exposed to direct sunlight. This could cause it to overheat and damage it beyond repair. • Never leave the device unattended during operation. • Never cover the device’s ventilation slots when it is switched on. • Do not place open flames, such as candles, on or near the device. - 7 • Due to the charging current, only batteries with appropriate capacities may be charged: Ni-MH batteries: -AA min. 1750 mAh/max. 2700 mAh -AAA min. 750 mAh/max. 1000 mAh Ni-Cd batteries: -AA min. 700 mAh/max. 1000 mAh -AAA min. 300 mAh/max. 600 mAh Should an attempt be made to charge batteries with significantly lower capacities, the batteries could be destroyed. • Charge exclusively rapid rechargable batteries of the types "Ni-Cd" and "Ni-MH". NEVER charge batteries of other types or non- rechargeable batteries. These are not suitable for recharging. If you do, both the battery charger and the inserted batteries could be damaged beyond repair. - 8 • Use the Rapid Battery Charger exclusively with the supplied power adapter resp. vehicle-adapter. Do not use the power adapter and the vehicle- adapter with appliances other than the Rapid Battery Charger. Should you do so, the Rapid Battery Charger, vehicle-adapter, power adapter, batteries and the other appliance could be irreparably damaged. Risk of injury • Keep children away from the connection cable and device. Children frequently underestimate the danger of electrical devices. • If the device has fallen down or is damaged it must no longer be used. Have the device checked by a qualified specialist and, if necessary, repaired. • Batteries must not be handled by children. Children can put batteries in their mouths and swallow them. If a battery has been swallowed, obtain medical assistance immediately. - 9 • Always store batteries out of the reach of children! There is a danger that children could swallow batteries! Due to the poisonous content of batteries there is a danger to life! • When charging batteries never leave the Universal Battery Charger unsupervised. • The batteries could become hot during charging. NEVER touch hot batteries! There is a risk of being burnt! After charging, first of all remove the power adapter of the Rapid Battery Charger from the plug socket. Then allow the batteries to cool down before removing them from the Rapid Battery Charger. • The Rapid Battery Charger, the supplied power adapter and the vehicle-adapter do not contain any user-serviceable components. Should the housing of these appliances (Rapid Battery Charger / Power adapter) be opened, the warranty expires! If repairs are needed, contact one of our service partners in your area. The addresses of our service partners can be found on the warranty card. This is supplied with the Universal Battery Charger. - 10 Thunder storms! Devices connected to mains power can be damaged during a thunder storm. If there is a thunder storm, always remove the mains plug from the socket. For damage caused by ... • opening the housings of the Rapid Battery Charger, power adapter or vehicle-adapter • attempted repairs made by non-qualified personnel • improper use of the Rapid Battery Charger, power adapter and/or the vehicle-adapter, no liability or warranty will be accepted! • Leakage of battery acids can occur, especially with old batteries. You should remove all batteries from the Rapid Battery Charger if you do not intend to use it for an extended period. You can thus protect the Rapid Battery Charger from damage caused by leaking battery acids. - 11 Notes on handling batteries The device uses batteries. Please note the following on handling batteries: Risk of explosion! Do not throw batteries into a fire. Do not recharge batteries. • Never open, solder or weld batteries. There is a risk of explosion and injury! • Check batteries regularly. Leaking batteries can damage the device. • If the appliance is not going to be used for long periods, remove the batteries. • If batteries leak, put on protective gloves. Clean the battery compartment and contacts with a dry cloth. - 12 Commissioning Stationary operation • Remove all components – Rapid Battery Charger, power adapter , vehicle-adapter and batteries – from the packaging. • Before taking the Rapid Battery Charger into use, check that all items are complete/available and free of visible damage. • Place the Universal Battery Charger on a straight, level, scratch and slip resistant surface. • Insert the low-tension plug of the power adapter into the power adapter connection on the Rapid Battery Charger. • Compare the technical details with those of your power supplier. If they match, insert the power plug into a mains power socket. The LED on the plug adapter lights up. The Rapid Battery Charger is now ready for use. - 13 Mobile operation With the supplied vehicle-adapter you can also connect the Rapid Battery Charger to the 12-V cigar lighter socket of a vehicle or into the 12-V on-board power supply socket of a...