Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
1.The Dryness Level settings cannot be changed while the dryer is running. 2.Press and hold the DRYNESS LEVEL button for 5 seconds. The dryer will beep, and “CF” will be displayed for 1 second followed by the current Dryness Level setting. 3.To select a new Dryness Level setting, press the DRYNESS LEVEL button again until the desired Dryness Level setting is shown. NOTE: While cycling through the settings, the current setting will not flash, but the other settings will flash. 4.Press START/PAUSE to save the Dryness Level setting. The Dryness Level setting you selected will become your new preset Dryness Level setting for all Sensor cycles. Drying Rack Option Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the drying rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The drying rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack. To use the drying rack 1.Open dryer door. A A.Front edge 2.Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure at the front of the dryer. AB A.Drying rack front edge B.Dryer back panel 3.Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces. NOTE: Do not allow items to hang over the edge of the drying rack. 4.Close the door. 5.Press the POWER/CANCEL button. 6.Select a Timed Dry cycle and temperature (see following chart). Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Fluff temperature setting. 7.You must select a time by pressing TIME ADJUST + (plus) or – (minus). Reset time as needed to complete drying. Refer to the following table. 8.Press START/PAUSE. This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting, and drying time. Actual drying time will depend on the amount of moisture items hold. Rack Dry Setting Temp. Time* (minutes) Wool Sweaters Block to shape and lay flat on the drying rack. Timed Dry Low 60 Stuffed toys or pillows Cotton or polyester fiber filled Timed Dry Low 60 Stuffed toys or pillows Foam rubber filled Timed Dry Air Fluff (no heat) 90 Sneakers or canvas shoes Timed Dry Air Fluff (no heat) 90 *Reset time to complete drying, if needed. DRYER CARE Cleaning the Dryer Location Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air. Cleaning the Lint Screen Clean the lint screen before each load. The control panel has an indicator light to remind you to clean the lint screen before each load. A screen blocked by lint can increase drying time. IMPORTANT: ¦Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics. ¦If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. Every load cleaning 1.The lint screen is located in the door opening of the dryer. Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove. 2.Push the lint screen firmly back into place. As needed cleaning Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer. Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup. To wash 1.Roll lint off screen with your fingers. 2.Wet both sides of lint screen with hot water. 3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup. 4.Rinse screen with hot water. 5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer. Cleaning the Dryer Interior 1.Apply a liquid, nonflammable household cleaner to the stained area of the drum and rub with a soft cloth until stain is removed. 2.Wipe drum thoroughly with a damp cloth. 3.Tumble a load of clean cloths or towels to dry the drum. NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye. Removing Accumulated Lint From Inside the Dryer Cabinet Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified perso...
Эта инструкция также подходит к моделям:Сушильные машины - Bravos W10260037A (2.54 mb)