Оценок - 0, средний балл: 5
(
)
)
|
Фрагмент инструкции
Never use abrasive scouring powders. Interior Wash interior compartments with mild soap and water. Do not use an abrasive powder, solvent, polish cleaner or undiluted detergent. Door Gasket The vinyl gasket may be cleaned with mild soap and water, a baking soda solution or a mild scouring powder. Care of Unit 1. Avoid leaning on the drawer fronts, you may bend the door hinge or tip the unit. 2. Exercise caution when sweeping, vacuuming, or mopping near the front of the unit. Damage to the grille can occur. 3. Periodic cleaning of the inside of the unit. (See Care and Cleaning of Your Drawer Refrigerator section). 4. Periodic checking and/or cleaning of the front grille and condenser coils as needed. Normal Responsibilities of the Owner • All freight charges • Damage sustained in transit • Mileage charge(s) for service calls • Proper installation including installation of leveling legs. • Leveling of unit. • Alterations to original equipment • Cleaning and normal maintenance outlined in this manual. Help Prevent Tragedies Each year, children die because they climb inside a discarded refrigeration product, get trapped inside and suffocate. Take precautions to prevent such tragedies by removing the door, taping or chaining it shut before discarding. All specifications and product design subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products. Troubleshooting Possible Cause CorrectionProblem Odor in cabinet • Unit interior needs cleaned. • Clean inside of unit. See “Care and Cleaning” pg. 7. Noisy operation • Unit not level. • Adjust leveling legs. See leveling leg instructions. Unit vibrates • Unit not level. • Adjust leveling legs. See leveling leg instructions. •Weak floor. • Rebuild floor or move to a different location. Interior light not working • LED light burned out. • Replace LED light. • No power at outlet. • Test outlet with lamp. Appliance will not run. • Control Panel turned “OFF”. • Turn unit on with on/off pad on Control Panel. • Line Cord not plugged into power source. • Plug unit into power source. • House fuse blown. •Reset house fuse. Appliance runs too long. • Prolonged door openings. • Reduce number and/or duration of door openings. • Control Panel set too cold. • Raise temperature of unit via Control Panel. • Condenser needs cleaning. • Clean condenser. See “Care of Unit” pg 7. Moisture collects inside of unit. • Too many door openings. • Reduce number and/or duration of door openings. • Prolonged door openings. • Reduce number and/or duration of door openings. • Hot, humid weather increases • As humidity decreases, moisture will disappear. condensation. • Move unit to cooler location. Moisture collects on outside surface • Hot, humid weather increases • As humidity decreases, moisture will disappear. of the unit. condensation. • Move unit to cooler location. Interior too hot/too cold • Control improperly set. • Control improperly set. • Faulty thermometer. • • • Reset to slightly warmer temperature. Reset control to desired temperature. Recheck with second thermometer. Diagnostic LED In the back in the grille there is a diagnostic/status LED. This led is used to help diagnosis any problems with the unit and to tell its status. LED Status Code/Problem Not on Unit does not have power Continuously on Unit is "ON" and operating correctly 1 Blink and pause For shorted or open thermistor 2 Blink and pause Disconnected Display Board 3 Blink and pause Compressor is locked out All specifications and product design subject to change without notice. Such revisions do not entitle the buyer to corresponding changes, improvements, additions, replacements or compensation for previously purchased products. Obtaining Service Before Calling for Service Before calling for service, check the following items: • Make sure unit is plugged into outlet. • Check the outlet for power. Test outlet with lamp to make certain outlet has power. • Make sure drawer refrigerator is “ON”. Display will show. • Make certain unit is level from front to back and side to side. • Use troubleshooting guide, page 8 for other diagnosis. If you are not able to correct the problem, contact your dealer or the manufacturer. Be sure to have the model number and the serial number handy before you call. The model and the serial number are located somewhere on your drawer refrigerator. How to Obtain Service Your drawer refrigerator requires little service because the best and most up-to-date materials, equipment and quality 3. In all correspondence regarding service, be sure to give the model number, serial number and proof of purchase. 4. Try to have information or description of the nature of the problem, how long the unit has been running, the room temperature and any additional information that may be helpful in quickly solving the problem. Every new drawer refrigerator that leaves the factory contains this...