Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
2. Don’t touch electrical switches. 1. Ouvrez les fenetres. 2. Ne touchez a aucun interrupteur. 3. Eteignez toute flamme nue. 3. Extinguish any open flame. 4. Avertissez immediatement votre fournis4. Immediately call your gas supplier. seur de gaz. FOR YOUR SAFETY Pour votre securite Do not store or use gasoline or other Ne pas entreposer ni utiliser de l’essence ni d’autres vapeurs ou liquides inflammables aflammable vapors and liquids in the proximite de cet appareil ou de tout autre vicinity of this or any other appliance. appareil. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to this manual. For assistance or additional information consult a qualified installer, service agency or the gas supplier. Avertissement: Une installation, un reglage, une modification, une reparation ou un entretien non conforme aux normes peut entrainer des blessures ou des dommages materiels. Lisez attentivement le mode d’emploi fourni avec l’appareil. Pour obtenir de l’aide ou des renseignements supplementaires, consultez un installateur ou un service d’entretien qualifie ou le fournisseur de gaz. USA Corporate Office CANADA Service Office 2320 Industrial Parkway Elkhart, IN 46515 Dometic Distribution Inc. Dometic Corporation 866 Langs Drive 2320 Industrial Pkwy. Cambridge, Ontario Elkhart, IN 46516 For Service Center Assistance N3H 2N7 Canada Phone: 574-294-2511 Call: 800-544-4881 Phone: 519-653-4390 ® English 822701314MO-FO 0448 (French 3309771.016) 3 2 - WAY display panel FIG. 2 3 - WAY display panel LEGEND 3-WAY Model 1. Main Power Button ON/OFF 2. DC Mode Selector Button 3. AUTO/GAS Mode Selector Button 4. Temperature Selector Button A. DC Mode Indicator Lamp B. AC Mode Indicator Lamp C. GAS Mode Indicator Lamp D. AUTO Mode Indicator Lamp E. CHECK Indicator Lamp (GAS Mode Only) F. Temperature Indicator Lamps G. Climate Control Switch LEGEND 2-WAY Model 1. Main Power Button ON/OFF 2. AUTO/GAS Mode Selector Button 3. Temperature Selector Button B. AC Mode Indicator Lamp C. GAS Mode Indicator Lamp D. AUTO Mode Indicator Lamp E. CHECK Indicator Lamp (GAS Mode Only) F. Temperature Indicator Lamps G. Climate Control Switch ON OFF AC GAS AUTO CHECK COLD 1 2 3 4 5 COLDEST ON OFF AC DC GAS AUTO CHECK COLD 1 2 3 4 5 COLDEST E B A C D D E B C 1 2 1 2 3 3 4 F F G 12V DC Relay, 3-Way only Power module cover FIG. 1 Flexible cord 12 volt DC Terminal block Drain water hose Inlet fitting Manual gas shutoff valve Burner jet Screw for protection cover Protection cover Flue baffle Heater(s) Thermofuse INSTALLATION INSTALLATION This appliance is certified under the latest edition of ANSI Z21.19•CSA 1.4 Refrigerators using gas fuel. The installation must conform with local codes, or in absence of local codes, the following standards as applicable. In the U.S. the installation must conform with: 1. National Fuel Gas Code, ANSI Z223.1/NFPA 54 (latest edition). 2. Recreational Vehicles Code, ANSI A119.2 (latest edition) 3. Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280. If an external electrical source is utilized, the refrigerator, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, the National Electrical Code, ANSI/NFPA 70 - (latest edition). In CANADA, the installation must conform with: 1. Natural Gas and Propane Installation Code, CSA B149.1 2. CSA Z240 RV Series, Recreational Vehicles. 3. Current CSA Z240.4, Gas-equipped Recreational Vehicles and Mobile Housing. If an external electrical source is utilized, the refrigerator, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, the Canadian Electrical Code, CSA C22.1, Parts I and II - (latest edition). VENTILATION The installation shall be made in such a manner as to separate the combustion system from the living space of the mobile home or recreational vehicle. Openings for air supply or for venting of combustion products shall have a minimum dimension of not less than 1/4 inch. Proper installation requires one lower fresh air intake and one upper exhaust vent. The ventilation kits shown in this instruction manual have been certified for use with the refrigerator models listed in the Table. For “Certified Vent System Kits” see page 16. The ventilation kits must be installed and used without modification. An opening toward the outside at floor level in the refrigerator compartment must be provided for ventilation of heavier-than-air fuel gases. The lower vent of the recommended kits is provided with proper size openings. The flow of combustion and ventilating air must not be obstructed. The lower side vent is fitted with a panel, which provides an adequate access opening for ready serviceability of the burner and control manifold of the refrigerator. This should be centered on the back of the refrigerator. GAS CONNECTION Hook up to the gas supply line is accomplished at...
Эта инструкция также подходит к моделям:Холодильники - RM2663 (466.45 kb)
Холодильники - RM2862 (466.45 kb)