Оценок - 1, средний балл: 5
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Push the water dis penser lever until the water runs from the outlet. NOTE A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer recommends using a water supply kit containing copper tubing. Checking the Parts Purifier (Interior model) Sealing tape Clip A x 8EA Tapping screw x 12EA Water line Purifier lock station Tightening band Purifier (Exterior model) 27 INSTALLATION INSTRUCTIONS INSTALLING OF THE WATER DISPENSER LINE For Interior Model (Case 1) Connecting to water supply line 1. Cold Water line 2. Pipe Clamp. - Shut off the main water supply line and turn the Ice maker to the off position. - Locate the nearest cold drinking water line. - Follow the instructions in the ice maker installation kit. 3.Copper (or Plastic) line 4.Compression Nut 5.Compression Sleeve 6.Shut Off Valve 7.Packing Nut. Connect the water line to the refrigerator Compression Nut - Slip the compression nut and plastic ferrule through the plastic tube. - After inserting the sleeve, tighten the compression nut onto 1/4” compression fitting(union). NOTE Do not overtighten the compression nut. - Slip the compression ferrule and nut on copper (or plastic) tubing as shown. Tighten the comperssion nut onto the compression fitting(union). -Turn water on and check for any leakege. NOTE Waterline must be connected to drinkable water only (Case 2) Check the water supply line Connect the water pipe with coupler and tap. - Close the main water tap. -Connect coupler “A” to the tap. Ferrule Sleeve Compression fitting Ferrule Compression Nut The water line must be connected to the cold water pipe. If it is connected to the hot CAUTION water pipe, it may cause the purifier to malfunction. - Every join should be protected with sealing tape. WARRANTY INFORMATION This water line installation is not covered by the refriger- ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage. COUPLER “A” Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase TAP the right couplers fittings. 28 INSTALLING THE WATER DISPENSER LINE COMPRESSOR COVER OF REFRIGERATOR - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. - When connected, check if there is any leakage. If any, repeat the connection. - Reattach the compressor cover of the refrigerator. CONNECTION NUT WATER LINE CLIP A WATER LINE - Using clip ”A”, fix the water line to the wallor (the back of refrigerator). - When the water line is secure, make sure whether the water line is not excessively bent, pinched or squashed. Complete the installation of the water supply line. - Power on the refrigerator and press the lever on the right of the dispenser until water runs out through the water line and all air has been empty. - At this time, check for any possible leakages at the join point in the water line. After securing the w...
Эта инструкция также подходит к моделям:Холодильники - 24KLDW (2.81 mb)
Холодильники - RS21FANS (2.81 mb)
Холодильники - RS24DAMS (2.81 mb)
Холодильники - RS24DANS (2.81 mb)