Оценок - 4, средний балл: 3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
EX) If the water filter was installed in March, put “MAR” -Remove the protective cap then position and insert the filter as shown, - Slowly turn the water filter clockwise 90. to align the indication mark on the cover, locking the filter in postion. Do not overtighten. INSTALLATION INSTRUCTIONS SEPARATION OF RED CAP STICKER (MONTH INDICATION) COVER FILTER ALIGN THE INDICATION MARK WITH LOCK POSITION. Caution Please check if the indication line aligns with the lock position. 29 INSTALLING THE WATER DISPENSER LINE For Exterior model Connect to the water supply line Connect the water pipe with coupler and tap. CAUTION The water line must be connect - Close the main water tap. ed to the cold water pipe. -Connect coupler “A” to the tap. If it is connected to the hot water pipe, it may cause the puri- Every join should be protected with sealing tape. fier to malfunction. WARRANTY INFORMATION This water line installation is not covered by the refriger- ator or ice maker manufacturer's warranty. Follow these instructions carefully to minimise the risk of expensive water damage. COUPLER “A” Note: If the coupler does not fit on the current tap, go the nearest authorised service dealer and purchase the right couplers fittings. TAP Select the location where the purifier is to install. (Model with the purifier) - Cut the water line attached to the purifier to the appropriate place after measuring the distance between the purifier and the cold water tap. - If you wish to reassemble the water inlet and outlet sides of the purifier during purifier installation, see the reference illustration. WATER INLET SIDE OF PURIFIER LINE OUTLET SIDE OF PURIFIER PURIFIER WATER COUPLER REFERENCE 90 degree Remove any residual matter inside the purifier. (Model with the purifier) - Open the main water tap to check whether water is running through the water tube on the water inlet side of the purifier. - If water does not come out through the line, check whether the tap is open. - Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed. WATER LINE PURIFIER OUTLET SIDE OF PURIFIER WATER 30 INSTALLING THE WATER DISPENSER LINE Attach the purifier lock stations. - Hold the purifier lock stations in the appropriate position (under the sink for example) and fix it tightly into place where to screw. INSTALLATION INSTRUCTIONS PURIFIER LOCK STATIONS TWO PURIFIER LOCK STATION TWO PURIFIER LOCK STATION BAND COMPRESSOR COVER OF REFRIGERATOR CONNECTION NUT WATER LINE WATER TUBE Secure the purifier in position. - Fix the purifier in position, as shown in the figure PURIFIER on the right. TIGHTENING Connect the water line to the refrigerator. - Remove the compressor cover of the refrigerator. - Connect the water line to the valve, as shown in the figure. -When connected, check if there is any leakage. If any, repeat the connection. - Reattach the compressor cover of the refrigerator. Secure the water line. -Using clip ”A”,...
Эта инструкция также подходит к моделям:Холодильники - 24KLDW (2.81 mb)
Холодильники - RS21FANS (2.81 mb)
Холодильники - RS24DAMS (2.81 mb)
Холодильники - RS24DANS (2.81 mb)