Оценок - 1, средний балл: 4 ( )

Производитель: AEG Размер: 759.56 kb Название файла: Язык инструкции:

In this case, the space behind the top cupboard must be at least 50 mm deep. 50mm Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the E.E.C. Directives. Removing the transport support Your appliance is equipped with transport support to secure the door during transportation. To remove them do these steps: 18 18 Installation 1. Open the door. 2. Remove the transport support from the door sides. 3. Remove the transport support from the lower hinge (some models). Some models are fitted with a silencing pad under the cabinet. Do not remove this pad. Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: 1. Move the shelf holders in the direction of the arrow (A). 2. Lift up the shelves in the rear edge (B) and push it forward until it is freed (C). 3. Remove the retainers. 32ABC Rear spacers Install the spacers provided within the accessory bag as shown in the figure. Install the spacers on the back side of the panel. Fitting the door handles (Example for right hinge performance) The handles are supplied as a kit at delivery. Installation 19 1. Screw the top handle bracket to the handle rod. 2. Fit the bottom handle bracket on the lower left-hand side of the door. 3. Fit the top handle bracket on the top left-hand side of the door. 4. Screw the handle rod to the bottom handle bracket. Do not use excessive force and overtighten the screws (max. 2 Nm) as you may damage the door handles. 1 2 43 Levelling When placing the appliance ensure that it stands level. If necessary adjust the feet using the adjustment spanner supplied. Door alignment is dependent on proper levelling. Installation of the Taste Guard Filter The Taste Guard Filter is an active carbon filter which absorbs bad odours maintain the best flavour and aroma for all foodstuffs without risk of odour cross contamination. On delivery the carbon filter is in a plastic bag to preserve performance. 1. Open the air lever flap. 2. Take the filter out of the plastic bag. 20 20 Installation 3. Insert the filter in the slot found in the back of the air lever flap. 4. Close the air lever flap. The filter should be handled carefully so fragments do not loosen from the surface. Make sure that the air lever flap is closed to obtain proper function. Door reversibility To change the opening direction of the door, do these steps: 1. Remove the plug from the power. 2. Remove the ventilation grille. Remove the upper filling and install it on the opposite side of the grille. Remove the pedal hole cover and install the cover provided in the accessory bag on the opposite side. 3. Lay down the appliance back side down o...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: