Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
• Unpack the appliance and check if there are damages on it. Do not connect the appliance if it is damaged. Report possible damages immediately to the place you bought it. In that case retain packing. • It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. • Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ventilation follow the instructions relevant to installation. • Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. • The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is accessible after the installation of the appliance. • Connect to potable water supply only. 3) 1) If the lamp cover is foreseen. 2) If the lamp is foreseen. 3) If a water connection is foreseen. Control panel 5 Service • Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. CONTROL PANEL 123456 1 2 3 4 5 6 ON/OFF button Mode button OK button Temperature colder button Temperature warmer button Display It is possible to change predefined sound of buttons to a loudly one by pressing together Mode button and Temperature colder button for some seconds. Change is reversible. Display/Indicator 43217856 1 2 3 4 5 6 Timer indicator COOLMATIC function Holiday function Temperature indicator Alarm indicator Child Lock function 6 6 Control panel 7 8 Minute Minder function Humidity function Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the power socket. 2. Press the ON/OFF button if the display is off. 3. If "dEMo" appears on the display, the appliance is in demonstration mode. Refer to "What to do if..." paragraph. 4. The temperature indicators show the set default temperature. To select a different set temperature refer to "Temperature regulation". If the door remains open for some minutes, the light will turn off automatically. The light is reset by closing and opening the door itself. Switching off To switch off the appliance do these steps: 1. Press the ON/OFF button for few seconds. 2. The display switches off. 3. To disconnect the appliance from the power disconnect the mains plug from the power socket. Temperature regulation The set temperature of the fridge may be adjusted by pressing the temperature button. Set default temperature: • +5°C for the ...
Эта инструкция также подходит к моделям:Холодильники - QR2520X (759.56 kb)
Холодильники - QR2520W (759.56 kb)
Холодильники - QR2520X (759.56 kb)
Холодильники - QR2520W (759.56 kb)