Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
Risk of grease filter catching fire due to flames. Restrictions apply to the use of the extractor hood over a solid-fuel burner (coal, wood, etc.). (See Installation instructions). Gas hobs / gas cookers Always use gas hobs in a proper and safe manner. Important: The flames from the gas hob must always be covered by pots or pans. ! ! The intense heat generated by the gas flames could cause damage to the extractor hood. Operating the extractor hood The most effective method of removing vapours produced during cooking is to: . Switch the ventilator ON as soon as you begin cooking. . Switch the ventilator OFF a few minutes after you have finished cooking. . The fans in this appliance can be switched to the desired setting by hand (manual mode) or can be controlled fully automatically with the automatic function according to your requirements (automatic mode). Switching on manual mode: Press the Lor + button. . The fan starts at Setting }. Appliances without automatic mode: Fan – off – Fan – on – Fan settings Fan settings – lower – – higher – Intermittent ventilation Light on / off Fan on / off Display: . Fan settings / Intensive setting . Saturation – grease filter # . Saturation – activated carbon filterr a Switching on the fan settings/intensive setting: 1. To increase the fan settings or switch on the intensive setting c, press the + button. . The intensive setting operates at maximum power which should be used only briefly. If the intensive setting is not switched off manually, the fan automatically switches back to Setting }after 10 minutes. 2. To switch off the intensive setting cor switch back to fan settings ~ – } – | and switch off the extractor hood completely, press the – button. Appliances with automatic mode: (Ultraschall-Sensor) Fan – off – Automatic mode Fan settings – lower – / Manual mode Fan . Saturation – on / off grease filter # Fan – on – Fan settings – higher – Intermittent ventilation Light on / off Display: . Fan settings / Intensive setting . Saturation – activated carbon filterr a Switching over to automatic mode: . To switch from manual mode to automatic mode at any time, press the U button. Operating the extractor hood Switching on automatic mode: Press the Ubutton. . The fan runs at least at Setting |. Fan settings: . If required, the optimum fan setting is actuated automatically via a sensor. . The automatic function operates at Settings | – ~. Intensive setting: 1. To switch on the intensive setting c, press the + button. . Automatic mode has been switched off. . The intensive setting operates at maximum power which should be used only briefly. If the intensive setting is not switched off manually, the fan automatically switches back to the optimum fan setting after 10 minutes. 2. To switch off the intensive setting, press the – button. . Automatic mode has been switched on again. Switching over to manual mode: . To switch from automatic mode to manual mode at any time, press the U button. Intermittent ventilation ....
Эта инструкция также подходит к моделям:Вытяжки - DHI665V/02 (13.34 mb)
Вытяжки - DHI665V/03 (13.34 mb)
Вытяжки - DHI665V/04 (13.34 mb)
Вытяжки - DHI665VGB/01 (13.34 mb)