Оценок - 2, средний балл: 3.5 ( )

Производитель: Haier Размер: 1.65 mb Название файла: Язык инструкции:

Check safety valve once a month as follow: move the small handle of safety valve, if there's water flowing out, safety valve is normal; if there's no water flow, please contact local after-sales service station. The pressure relief device is to be operated regularly to remove lime deposits and to verify that it is not blocked. NO pressure release hole 5 Setting Environment . »O .° .. °O UI .· .A AE ®. A. O· . Description of the Symbols Do not set it at place where is too cold and may freeze. Do not set at outdoor places. Do not use as floorstanding appliance. Please mount it to firm and reliable wall. Do not install to places without sewer. In case connecting water heater with water drain hose, connect the drain hose to the inlet of the sewer to avoid polluting by splashing. The original pipeline of the water heater is an organic part of "Safe Care". Do not remove it by yourself. Otherwise we will not take responsibility for the injure and loss caused by the safety trouble occurred therefrom. Never do that Be sure to act as per instructions 6 Installation Connection and use of safety valve: The safety valve should be connected to the cold water inlet pipe. Please check carefully if the direction is correct after installation. The correct direction of installation is that the arrowhead on the safety valve should point to the water heater. Please connect the drain hose to the safety valve. Connect one end of the hose to the safety valve vent and the other end to the sewage drain. The hose can be cut short or extended as necessary. The hose shall be installed as inclined downward.(see to Figure 4) (Figure 3) for reference in installation only Cold water inlet Mixing valve Hot water outlet valve Cold water outlet valve Shower head Hot water outlet Safety valve Installation must be made by installers of or designated by our company after-service department. The water heatershall be wall-mounted. Before installation, make sure water heater rear wires are fit firmly. Determine an installation location. Make four holes 12mm, 65 mm deep in the wall with an impact drill according to installating dimension. Insert fixexpansion hooks and expansion bolts in corresponding wall holes. Lift the water heater. Insert wall rack onto the hooks and bolts. Fit flat washers, rear wires and nuts in turn onto the bolts (see Figure 2). Tighten the nuts and check them firm. Install accessories such as safety valve, drain hose as shown in Figure 3. Use sealing compound to prevent water leakage. (Figure 2) To facilitate installation and removal, it is suggested a G 1/2" movable nut is fitted at appropriate locations on inlet and outlet pipes respectively. Find water supply location. Connect inlet pipe, outlet pipe and city water pipe respectively to the use point. The hot water pipe shall not be too long to reduce the heat losses. Please reserve some space in installation for the future maintenance. ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: