Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
Water analysis shows whether water is hard or soft. Hard water, unless treated, will cause scaling or liming of the heat exchanger. The rate of scaling increases with temperature and usage because calcium carbonate and other scaling compounds lose solubility (fall out of solution) at higher temperatures. For example, for every 20°F over 140°F, the rate of scale increases by a factor of 2 (See figure below). Reference target water quality levels found in the operation / installation manual and consider water treatment if these levels are exceeded. * BASED ON 10 grains/gal HARDNESS * 210 180 150 120 90 60 30 0 LIME DEPOSITED, lb/ yr 180°F 170°F 160°F 150°F 140°F 120°F 39003300270021001500900300 0 WATER USAGE, gal/day *Source 2003 ASHRAE Handbook HVAC Applications 4 Pump Sizing for Circulation Pump Sizing for Circulation 1. Use the chart below or one appropriate for your conditions to determine the heat loss in the length of the hot water supply and return piping. For example, 100 ft of 1-1/2 in bare copper tubing results in a heat loss of 5300 Btu/h. Approximate Heat Loss from Piping at 140 .F Inlet, 70 .F Ambient * Nominal Size, in. Bare Copper Tubing, Btu/h-ft 1/2 in. Glass Fiber Insulated Copper Tubing, Btu/h-ft 3/4 30 17.7 1 38 20.3 1-1/4 45 23.4 1-1/2 53 25.4 2 66 29.6 2-1/2 80 33.8 3 94 39.5 4 120 48.4 * Source: 2003 ASHRAE Handbook HVAC Applications 2. Determine the acceptable temperature drop at the last fixture in the loop. For example, if the supply temperature from the water heater is 120 .F (49 .C) and an acceptable temperature at the last fixture is 100 .F (38 .C) then the acceptable temperature drop is 20 .F (7 .C). 3. Calculate the required pump flow rate using the following formula: FLOW RATE (gpm) = HEAT LOSS (BTU / h) 500 X ACCEPTABLE TEMPERATURE DROP (.F ) 4. Based on the above calculations select a pump for the type of circulation system you will be utilizing: A). Preferred Method (reference drawing WH-1-RGE) - Reference pump manufacturers flow vs. pressure specifications to select a pump that can provide the flow rate calculated above while overcoming the pressure loss through: • Tank water heater (reference manufacturer’s information) • All building supply and return plumbing in the circulation loop (reference local plumbling codes, standards, or practices) B). Optional Method (WH-1-R) - Reference pump manufacturers flow vs. pressure specifications to select a pump that can provide 3 gpm of flow or the flow rate calculated above, whichever is greater, while overcoming the pressure loss through: • Tankless water heater (reference flow vs. pressure curve of the model being used) • Optional storage tank (reference manufacturer’s information) • All building supply and return plumbing in the circulation loop (reference local plumbling codes, standards, or practices) NOTE: Only use pumps of brass or stainless steel construction. Do not use pumps of iron construction as they will oxidize and clog the inlet filter on the appliance. 5 ...
Эта инструкция также подходит к моделям:Водонагреватели - 186965-000 (500.65 kb)
Водонагреватели - AGT-705-NE (500.65 kb)
Водонагреватели - AGT-705-PE (500.65 kb)
Водонагреватели - AGT-705-PI (500.65 kb)