1.3 Introduction Introduction 64 and VK-16. See P. 153 for the functions not available in the Viewer Only mode. *VK-16 has the same functionality as VK-64 outlined in this manual, unless explicitly indicated otherwise. Request to Customers (1) Canon owns the copyright of this manual. The unauthorized transfer of all or any part of the contents of this Manual is forbidden. (2) The content of this manual is subject to change without notice. (3) All possible measures have been taken to ensure that

You can control the exposure. .. • .. VB-M600D VB-M600VE Click the desired position in the image and the camera angle will move to center that position on the screen. However, if the position clicked is beyond the range of the pan or tilt, the camera angle will move only in the pan or tilt direction that is within the valid range of movement. Note If the camera moves in a different way from operation control or cannot be set to the range indicated by operation assist, then operation assist may n

Reset Switch Turn on the power while pushing this switch using a sharp object. Continue to push the switch for 5 seconds or more to restore all factory settings except for the date and time. SD card cover Audio input terminal (dual LINE IN and MIC IN) • • Installing the Camera Before installing the camera, set the IP address and other network information on the camera using the “VB Initial Setting Tool” on the Setup CD-ROM. For details on how to operate the “VB Initial Setting Tool,” see “VB-M70

This item need not be set if [No Authentication] was selected. [IPsec] Setting IPsec [IPsec] Setting IPsec g [SA ESP SPI (inbound)] Set the SA SPI value for inbound. Set a desired value in the range of 256 to 4294967295. Since this setting is used as an ID for identifying the SA, be careful not to specify an inbound SPI whose value is already used in the SPI for other ESP. • If [Security Protocol] was set to [AH] or [ESP and AH]] in 5, Aq [SA AH h [SA AH Authentication Algorithm] to S SPI (inbou

This “Installation Guide” explains the installation method of the camera. Be sure to read the “Safety Precautions” section for correct use. After reading this Installation Guide, keep it in a readily accessible location for future reference. The detailed procedures for using this camera are explained in the “Operation Guide”. Read these guides carefully before using the camera to ensure correct use. * For the latest information (firmware and included software, user manuals, operating environment

W040 Clearing to external memory [info] Description %1 the image storing - %2 (W040) %1 Starting or stopping %2 Reason for starting/stopping Meaning Started or stopped clearing stream recording to external memory. List of Log Messages List of Log Messages Description user not found (W101) Meaning The camera was accessed by an unauthorized user. W102 Invalid password [notice] Description user password mismatch (W102) Meaning The password is invalid W111 Invalid host [notic