Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
Mute: To temporarily mute Base Station, hold the Volume and Talk buttons down for three seconds. The Base Station will reactivate after one hour, or by pressing the Talk button. Remote Button: If there is an accessory device connected to the relay on the PIR Motion Sensor, it can be activated by pressing the Remote button within 30 seconds of the signal from the alert buzzer. On/Off: To turn Base Station OFF hold down the Volume button until a beep is heard and light goes out. To turn Base Station ON press the Talk button. Switch #1: Switch #2: Battery: The AA Alkaline batteries (not provided) will last up to 2 years depending on use (Lithium batteries recommended for colder environments). If PIR Motion Sensor batteries are low Base Station will emit three high-pitch beeps every ten minutes. If Base Station batteries are low it will emit two high-pitch beeps. Clear Memory: Press and hold the Learn button on the Base Station until 3 beeps are heard. If PIR Motion Sensor signals while Learn button is pressed, repeat the procedure. Programming Additional PIR Motion Sensors: Each Base Station can learn the code of up to 8 PIR Motion Sensors, responding with multiple buzzes. To program additional PIR Motion Sensors see Step 6. Carton Inventory Overview The Alert can be used to monitor motion in up to 8 locations up to 1000' from the Base Station. The Passive Infra-Red sensor detects movement of people and vehicles, while allowing small animals to pass through undetected. When the PIR Motion Sensor detects movement a signal is sent to the Base Station which alerts the user with sounds and lights. The PIR Motion Sensor has a built-in microphone that lets you hear what is going on outside and speak with a person on the other end. The Alert can also remotely control a low voltage electrical device near the PIR Motion Sensor like a light or a camera. The Alert system is compatible ONLY with the Models PIRV400R and AOSV Motion Sensors. Base Station Passive Infra-Red (PIR) Motion Sensor Swivel BushingMounting Plate AC Adapter Rubber Pads Operation & Features Intercom Feature: When PIR Motion Sensor has detected motion, the Base Station will allow you to listen through the PIR Motion Sensor for 10 seconds. If you wish to talk to the person on the other end, hold down the Talk button and speak, releasing it to hear. Volume Button Talk (Power - On) Microphone Remote Activation Button Learn Button Switch #1: Mute Switch #2: Tone AC Adapter Relay Output Contacts 1 2 ON OFF OFF Speaker Muted ON Speaker On (Default) OFF Long Beep ON Short Beep (Default) To prevent possible SERIOUS INJURY or DEATH from electr...
Эта инструкция также подходит к моделям:Видеонаблюдение - WIRELESS ALERT CWV1000 (1.12 mb)