Оценок - , средний балл:
(
)
)
Производитель: Nikon
Размер: 16.76 mb
Название файла:
Язык инструкции:
Документ загружается, подождите пожалуйста
 |
Документ загружается, подождите пожалуйста
К этому устройству также есть другие инструкции:
Фрагмент инструкции
• To exit the menus and return to shooting mode, press the s shutter-release button halfway (044). Help If a d icon is displayed at the bottom left by pressing the L(Z/Q) button. corner of the monitor, help can be displayed A description of the currently selected option or menu will be displayed while the button is pressed. Press 1or 3to scroll through the display. L(Z/Q) button 22 First Steps Charge the Battery The D4 is powered by an EN-EL18 rechargeable Li-ion battery (supplied). To maximize shooting time, charge the battery in the supplied MH-26 battery charger before use. About two hours and twenty minutes are required to fully recharge the battery when no charge remains. 1 Plug the charger in. Insert the AC adapter plug into the battery charger and plug the power cable into an electrical outlet. s 2 Remove the terminal cover. Remove the terminal cover from the battery. Terminal cover 3 Remove the contact protector. Remove the contact protector from the charger battery chamber. A See Also For information on using the MH-26 to charge two batteries, see page 441. 23 4 Charge the battery. Insert the battery (terminals first), aligning the end of the battery with the guide and then sliding the battery in the direction indicated until it clicks into place. The chamber lamp and charge lamps will flash slowly while the battery charges: Guide Chamber lamps Contacts Charge lamps (green) s Charge state Chamber lamp Charge lamps 50% 80% 100% Less than 50% of maximum capacity H(flashes slowly) H(flashes slowly) I (off ) I (off ) 50–80% of maximum capacity H(flashes slowly) K(glows) H(flashes slowly) I (off ) More than 80% but less than 100% of maximum capacity 100% of maximum capacity H(flashes slowly) K(glows) K(glows) I (off ) K(glows) I (off ) H(flashes slowly) I (off ) Charging is complete when the chamber lamp stops flashing and the charge lamps turn off. About two hours and twenty minutes are required to fully charge an exhausted battery; note that the battery will not charge if its temperature is below 0 °C (32 °F) or above 60 °C (140 °F). 5 Remove the battery when charging is complete. Remove the battery and unplug the charger. D Calibration See page 440 for more information on calibration. 24 Insert the Battery 1 Turn the camera off. D Inserting and Removing Batteries Always turn the camera off before inserting or removing batteries. 2 Remove the battery-chamber cover. Lift the battery-chamber cover latch, turn it to the open (A) position (q) and remove the BL-6 battery-chamber cover (w). s 3 Attach the cover to the battery. If the battery release is positioned so that the arrow (4) is visible, slide the battery release to cover the arrow. Insert the two projections on the battery into the matching slots in the cover and slide the battery release to completely reveal the arrow. D The BL-6 Battery-Chamber Cover The battery can be charged with the BL-6 attached. To prevent dust from accumulating inside the battery chamber when the battery is not inserted, slide the battery release in the direction indicated by the arrow (4), remove the BL-6 from the battery, and replace it on the camera. Other battery covers can not be used with this camera. 25 4 Insert the battery. Insert the battery as shown at right. 5 Latch the cover. To prevent the battery from becoming dislodged during operation, rotate the latch to the closed position and fold it down as shown at right. Be sure the cover is securely latched. s A Removing the Battery Before removing the battery, turn the camera off, lift the battery-chamber cover latch, and turn it to the open (A) position. Note that the battery may be hot after use; observe due caution when removing the battery. To prevent short-circuits, replace the terminal cover when the battery is not in use. D EN-EL18 Rechargeable Li-ion Batteries The supplied EN-EL18 shares information with compatible devices, enabling the camera to show battery charge state in six levels (040). The Battery info option in the setup menu details battery charge, battery life, and the number of pictures taken since the battery was last charged (0351). The battery can be recalibrated as necessary to ensure that battery level continues to be reported accurately (0440). 26 D The Battery and Charger Read and follow the warnings and cautions on pages xiii–xv and 408–411 of this manual. Do not use the battery at ambient temperatures below 0 °C/32 °F or above 40 °C/104 °F; failure to observe this precaution could damage the battery or impair its performance. Capacity may be reduced and charging times increase at battery temperatures from 0 °C/ 32 °F to 15 °C/59 °F and from 45 °C/113 °F to 60 °C/140 °F. Do not short the charger terminals; failure to observe this precaution could result in overheating and damage to the charger. Charge indoors at ambient temperatures of 5–35°C/41–95 °F. Battery capacity may temporarily drop if the battery is charged at low temperatures or used at a temperature below the temperature at which...