If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area apply a bi-polar switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over- current category III, in accordance with installation instructions. IMPORTANT: Before re-connecting the hood circuit to t

54 Description of the Appliance • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • The hood is supplied as an extractor unit and can also be used with a recirculation mode by fitting a charcoal filter. Extraction mode • In this mode fumes are extracted to the outside via a hose connected to the coupling ring. Fig. 1 • In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Recirculation mode • The ai

• External surfaces are susceptible to scratches and abrasions, so please follow the cleaning instructions to ensure the best possible result is achieved without damage. Stainless steel surface Clean stainless steel surfaces using non-abrasive cleaning products that are specifically for use on stainless steel. To ensure best results also use an even pressure and follow the grain of the stainless steel. Use of a soft cloth reduces the risk of scratching. If the cloth is wet ensure that a dry soft

Always cover lit gas burners with pots or pans when canopy rangehood is in use. Always switch off gas burners before you remove pots or pans. Do not leave lit gas burners exposed due to the risk of fire. (Fig. 2) Fig. 1 Fig. 2 100mm500mm391mmO163mm* 900mm1175mm(maximum) 328mm593mm electrolux e:line rangehoods dimensions / electrical connection 4 Dimensions Electrical connection Canopy dimensions NOTE: *The fan housing exhaust outlet is 163mm in diameter. Use duct transition or flexible pipe supp

You agree that any replaced Appliances or parts become the property of Electrolux. This warranty does not apply to light globes, batteries, filters or similar perishable parts. 4. Parts and Appliances not supplied by Electrolux are not covered by this warranty. 5. You will bear the cost of transportation, travel and delivery of the Appliance to and from Electrolux or its ASC. If you reside outside of the service area, you will bear the cost of: (a) travel of an authorised representative; (b) tra

To interrupt the Intensive speed, press button A or B. H -Light OFF I -Light ON A B C D E F G H I Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. Control device for grease and activated charcoal filters This hood is fitted with a device that signals when it is necessary to clean the grease filter or the activated charcoal filter (in the case of recirculation version with activated charcoal filter). On delivery

NOTE: Do not remove the outer trim ring (lamp assembly). • Grasp the bulb and pull it straight out. • Replace with 12 volt, 20 watt halogen bulbs with a G4 base SUITABLE FOR USE IN OPEN LUMINAIRES. Follow package dir Follow package dirFollow package dirFollow package dirFollow package dirFollow package directions, wear gloves, do not ections, wear gloves, do notections, wear gloves, do notections, wear gloves, do notections, wear gloves, do notections, wear gloves, do not touch bulb with your ba

Safety Warning: Turn off power circuit at service panel and lock out panel, before wiring this appliance. Requirement: 120 V AC, 60 Hz. 15 or 20 A Branch Circuit Important safety Instructions READ AND SAVE THESE INSTRUCTIONS Important safety Instructions FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPORS. TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manu