Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Listed by Underwriters Laboratories Specification Created 11/08 130677 ZVB30SNSS Separate Raise/ Lower Switch All 30" models are equipped with a separate raise/lower switch. The switch must be installed in a separate location outside of the vent and cooktop cutout. Countertop Requirements Countertops must have a deep flat surface to accommodate the cooktop and the vent. Countertops with a rolled edge and backsplash may not provide the flat surface area required. Base Cabinet Requirements The base cabinet must be deep enough to accommodate the minimum clearance to the front edge of the countertop, the cooktop burner box and the vent. Downdraft Vent and Cooktop Cutout The installation of these downdraft vents with any Monogram cooktop requires careful consideration. For accurate planning, review the individual dimension drawings for the combined vent and Monogram cooktop installation. Before you begin you must: 1. Review countertop dimension illustrations to be sure you will have enough flat countertop surface depth. 2. Check to be sure that the total countertop depth required (including minimum cutout to front edge depth) allows enough space for a backsplash. 3. Review the cabinet illustration. Check to be sure that the interior cabinet depth will house the cooktop burner box, the vent and the cutout clearance from the front. 4. When countertop and cabinet depth present a problem, review Creative Solutions. 5. Carefully review the installation instructions packed with product or available online at With careful planning you can achieve a custom look with minimal adjustments. Creative Solutions 605Dia161DOWNDRAFT VENT1-7/8" TrimAdd a Bullnose Trim or Decorative Molding to Increase Countertop Depth and to Maintain Required Clearance FromFront Edge 605Dia159Base CabinetFiller PanelBase SinkFiller PanelMaintain Cutout Clearancesto Front Edge as Specified Decorative trim When the cutout to front edge of the countertop requirement is more than 2", add a bullnose trim to the front edge of the countertop. The additional trim allows the cooktop to be moved forward, providing additional countertop depth and interior cabinet space. Against-the-wall installation Move the base cabinet forward, 3" to 5". Filler panels or complimentary moldings can be added to the exposed cabinet sides. Optional Accessories JXRB67 Accessory for indoor remote location of the blower/ motor assembly. Use this kit when the blower and motor assembly will be located outside of the cabinet, such as below the cabinet floor. The assembly will fit between 16" floor joists. JXBC67 Outdoor cover accessory for remote installation of the blower/motor assembly on an outside wall. Ductwork Prepare the ductwork to vent to the outdoors. • Plan the shortest and straightest route for venting exhaust to the outdoors. • The maximum permissible length for the duct run is 150 feet. • Use metal ductwork only. • The downdraft blower system is designed to use 3-1/4" x 10" duct. It can be...
Эта инструкция также подходит к моделям:Вентиляторы - GE Monogram ZVB30BNBB (315.97 kb)
Вентиляторы - GE Monogram ZVB30SN (315.97 kb)
Вентиляторы - GE Monogram ZVB30SNSS (315.97 kb)