Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Low: This mode is recommended for normal daily operation. The ventilator will operate at its minimum speed continuously. The power indicator light will be lit yellow when this mode is selected. Intermittent: This mode is recommended when the inside air is too dry in the heating season or too humid in the cooling season. The ventilator will operate at its minimum speed for 20 minutes per hour and be off for 40 minutes per hour. The power indicator light will be lit green when this mode is selected. Off: To turn the ventilator off, press “Push” until the power indicator light is turned off. OPERATING YOUR ENERGY RECOVERY VENTILATOR (ERV) WITH BASIC, STANDARD AND AUTOMATIC CONTROL Your ERV is designed to operate as an integral part of your total heating and cooling system (See Fig. 2). Low Exchange Mode—If the relative humidity inside the building is lower than selected, air exchange would occur with the outside at high speed. If the relative humidity level inside the building is higher than selected, air exchange would occur outside at low speed. This ensures continuous air exchange for constant air quality. Intermittent Mode—If the relative humidity inside the building is higher than selected, no air exchange would occur, and the system would turn off. If the relative humidity inside the building is lower than selected, air exchange would occur with outside at high speed. This mode is ideal for maintaining the proper humidity level when the continuous mode cannot. ! WARNING ELECTRICAL SHOCK HAZARD Failure to follow this warning could result in personal injury or death. Before servicing system, always turn off main power to system. Turn off accessory heater power if applicable. There may be more than 1 disconnect switch. CAUTION! PERSONAL INJURY HAZARD Failure to follow this caution may result in personal injury. Although special care has been taken to minimize sharp edges in the construction of your unit, be extremely careful when handling parts or reaching into the unit. PERFORMING ROUTINE MAINTENANCE 1. The motors are factory lubricated. Lubricating the bearings is not recommended. 2. Thecoreshouldbevacuumedeverythreemonthstoremove dustthatwould inhibitthe energy transfer. Do not use water. The core should only be serviced when the outdoor temperature is between 60°F(16°C) and 75°F(24°C) and dry. Note: If the edges of the core are soft, do not try to service the core. The air passages can be damaged and/or closed off by handling it or trying to remove it. 3. A dirty air filter will cause excessive strain on the blower motor. The filters in your ERV are washable and should be cleaned every 3 months. Use a vacuum cleaner to removethe heaviest portion of accumulated dust, then wash in warm water. Note: Do NOT clean these filters in a dishwasher or dry them with heating appliances as they wil be permanently damaged. Use lukewarm water to clean filters. Replace filters only when they are completely dry. 4. Regularly check the screen on the exterior i...
Эта инструкция также подходит к моделям:Вентиляторы - ERVCCSHA (135.93 kb)
Вентиляторы - ERVCCSVA (135.93 kb)