Оценок - 1, средний балл: 3
(
)
)
|
Фрагмент инструкции
Use and Care Information WARNING — TO REDUCE THE WARNING — TO REDUCE THE SMOTHER FLAMES with a close- RISK OF FIRE, ELECTRIC RISK OF A RANGE TOP GREASE fitting lid, cookie sheet, or metal SHOCK, OR INJURYTO FIRE: tray, then turn off the burner. BE PERSONS, OBSERVE THE Never leave surface units CAREFUL TO PREVENT BURNS. If FOLLOWING: Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. Before servicing unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings. the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT. NEVER PICK UP A FLAMING PAN —You may be burned. or cleaning unit, switch power off at service panel and lock switch power off at service panel and lock service panel to prevent power from being Always turn hood ON when cooking at high heat or when cooking flaming foods. Clean ventilating fans frequently. Grease should not be allowed to DO NOT USE WATER, including wet dishcloths or towels — a violent steam explosion will result. Use an extinguisher ONLY if: switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning accumulate on fan or filter. Use proper pan size. Always use cookware appropriate for the size of the surface element. You know you have a Class ABC extinguisher, and you already know how to operate it. device such as a tag to the service panel. WARNING — TO REDUCE THE RISK OF INJURY TO PERSONS IN The fire is small and contained in the area where it is started. CAUTION: For general THE EVENT OF A RANGE TOP The fire department is being ventilating use only. Do not use GREASE FIRE, OBSERVE THE called. to exhaust hazardous or explosive materials and vapors. FOLLOWING: You can fight the fire with your back to an exit. Replacing the Halogen lamps: The hood liner uses 12-volt, 20 watt halogen lamp bulbs. Before you begin, make sure that the range hood is turned off and that the lamps have had sufficient time to cool. To replace a halogen lamp: • Remove 2 screws from the circular metal trim around the lamp assembly. • Pull the trim with the lamp assembly attached down far enough so that the lamp can be pushed out of the socket clips. • Insert the new lamp into the socket clips and push the lamp and trim assembly back up into the hood. • Replace the screws. Operation The hood liner is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from cooking area. blower speed switch blower motor light switch switch Operating the lights: ON: Move the light switch to the “1” position. OFF: Move the light switch to the “0” position. Operating the exterior blower motor: ON: Move the blower motor switch to the “1” position. The blower will begin operating at the speed set on the speed switch. OFF: Move the blower switch to the “0” position. Adjusting the exterior blower speed: Adjusting exterior blower motor speed: Move speed control switch to vary the blower speed from low (at the left) to high (at the right). The exterior blower motor will operate at the speed set when the motor is turned on. Cleaning Filters: the filters should be washed frequently. Place metal filters in dishwasher or hot detergent solution to clean. To remove filter: Use two hands to remove filter. Push tab back to release the locking pin, pull down and forward. Repeat with other filter(s). To reinstall filter: Place back edge of filter into channel at rear of hood liner. Push filter up while pushing tab back. When filter is in place, release tab. Locking pin will hold filter in place. Repeat with other filter(s). Exterior surfaces: • Do not use steel wool or soap- filled scouring pads. • Rub in direction of the grain line to avoid marring the surface. • Always wipe dry to avoid water marks. • KitchenAid® Professional Formula Stainless Steel Cleaner & Polish is the cleaner recommended for cleaning stainless steel surfaces on this product. To order call our Cust...
Эта инструкция также подходит к моделям:Вентиляторы - KPEC992M (445.17 kb)
Вентиляторы - KPEC992M (445.17 kb)
Вентиляторы - KPEC992M (445.17 kb)
Вентиляторы - KPEC992M (445.17 kb)