Оценок - 5, средний балл: 4
(
)
)
|
Фрагмент инструкции
tricity main, with a contact opening distance of at least 3 mm, such separating device The air collected must not be conveyed into ensuring disconnection from the main must a duct used to blow off smokes from ap be included in the fixed installation. pliances fed with an energy other than electricity (central heating systems, ther- Always switch off the electricity supply bemosiphons, water-heaters, etc.). fore carrying out any cleaning or servicing operations on the appliance. Comply with the official instructions provided by the competent authorities in merit when installing the disposal duct. In addition, exhaust air should not be discharged into a USE wall cavity, unless the cavity is designed for that purpose. Avoid using materials which could cause The room must be well aerated in case a spurts of flame (flambees) near the aphood and some other heat equipment fed pliance. with an energy other than electricity (gas, When frying, take particular care to prevent oil, coal heaters, etc) operate at the same oil and grease from catching fire. Already time. used oil is especially dangerous in this re- In fact the intake hood, disposing of air, could spect. Do not use uncovered electric grates. create a vacuum in the room. The vacuum should not exceed 0,04mbar. This prevents To avoid possible risks of fire always comthe gas exhausted by the heat source from ply with the indicated instructions when being intaken again. It is therefore advisable cleaning anti-grease filters and when re- to ensure the room contains air taps able to moving grease deposits from the appliance. ensure a steady flow of fresh air. ATTENTION: This appliance must be grounded. MAINTENANCE The following warning is valid in the United Kingdom only: Thorough servicing guarantees correct and long-lasting operation. As the colours of the wires in the mains lead of this appliance may not correspond Particular care must be paid to the anti- with the coloured markings identifying the grease filters which must be periodically terminals in your plug, proceed as follows: cleaned in relation to use (at least once – the wire which is coloured green and every two months). Remove the anti-grease yellow must be connected to the termi- filters and wash them either by hand or in nal in the plug which is marked with the the dishwasher using neutral detergent. letter E or by the earth symbol [ ], or Use lukewarm water and neutral detergent coloured green or green and yellow; to clean painted appliances. Never use – the wire which is coloured blue must be products containing abrasives. connected to the terminal which is marked Take great care to prevent the use of cor with the letter N or coloured black; rosive or abrasive products when cleaning – the wire which is coloured brown must steel, copper or brass appliances. It is advi be connected to the terminal which is sable to use specialized products accord- marked with the letter L or coloured red. ing to the manufacturer’s instructions. DESCRIPTION This appliance consists a hood and telescopic the telescopic structure itself. The appliance can be used in and ducting version. In the Filtering version (Fig. 1), the air and vapours conveyed by the appliance are by carbon filters and recirculated around the room through the air vents of the flue. ATTENTION: When using the Filtering version, two carbon filters must be installed plus an air switch A (Fig. 1). Positioned in the upper part of the structure, this allows the air to be recirculated throughout the room. In the Ducting version (Fig. 2), cooking vapours and odours are conveyed directly to the exterior through an outlet flue which exits from top or back of the apparatus and through the ceiling. Use of carbon filters is therefore unnecessary. INSTALLATION It is advised to follows carefully all the assembling steps and to make sure, once the assembling operation is over, that the appliance is fixed steadily; it is moreover advised to have skilled workers to assemble it. Remove the anti-grease filters before proceeding with the assembly instructions. This will make the appliance easier to handle. To remove the anti-grease filters (Fig. 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. Proceed with these instructions in reverse when refitting the filters. The following operations are essential for assembly: – Install the wiring system within the decorative pipe. – Prepare the air venting hole if your appliance is to be installed in the Ducting version. Once having established the desired position, assemble the equipment in the following way: INSTALLING Using the relative in the ceiling in alignment Mind thet one of the must be in correspondence of the controls of the hood. Since this model can dispose either the top or side, position the structure through openings A or B (required, in compliance with the following – The side of the structure with opening B (Fig. 4) must always point ...