Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Some ductwork is required to exhaust the unit out of the cabinet. CFM Reducer Kit cfmred For use in make up air environments where an under 300 cfm hood is required. This kit reduces the ducting to 5" round and reduces the cfm to under 300 FABER For a streamlined look in the kitchen, the Cristal HC is your integrated solution. The Cristal HC has a sleek pull-out visor which slides in, flush with your cabinets, neatly tucking the hood away. For total integration, the front strip can be replaced with material to match your cabinets, hiding the hood completely. Choose from a white, black, or brushed aluminum front strip (all are included in the box). For a totally integrated look, the front strip can also be replaced with a custom built strip to match your cabinets. See reverse for front strip dimensions. p.o. box 435 • Wayland, MA 01778 • tel: (508) 358-5353 • fax: (508) 358-5730 • e-mail: info@faberonline.com • Dimensional Diagrams Custom Front Panel Dimensions 1 15/32” 29 7/8” or 35 7/8 Note: The Cristal HC comes standard in the top vent position. The direct rear vent position can be achieved by rotating the blower housing. Side View 3 3/8" H CQ Oi 18" Bottom View E t 29 7/8" - 35 7/8" Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing this rangehood. The recommended height to install this hood off the cooktop is a minimum of 24" and a maximum of 30" for maximum effectiveness. Also consult the cooktop manufacturer's recommendation. Pre-Planning Your Ductwork - Important: Consult the installation instructions before you begin installing this rangehood. Make your ductrun as straight and short as possible. The ductrun should not exceed 35 equivalent feet if ducted with the required minimum of 6" round duct. Count 45° angles as 3 feet, 90° elbows as 5 feet, and 90° flat elbows as 12 feet. Recirculating Installations For installations where ductwork to the outside of your home is impossible or highly impractical Charcoal Filters, which attach to the blower assembly, absorb smoke and odors. ceiling For best results, use no more than three 90° elbows. Make sure that there is a minimum of 24" of straight duct between elbows if more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood's exhaust opening as possible. cabinet , vent grate I 6” round I ' duct ' hood soffit ceiling vent grate ►► cabinet 6” round duct hood For more efficient airflow when venting to the rear: Rotate the Cristal HC blower housing so that the 6" round exhaust outlet faces the back, rather than running ductwork up and elbowing back. WARNING! Product specifications are subject to change without notification. Consult the installation instructions before you begin installing this rangehood. Some ductwork must be installed to exhaust the rangehood back into the kitchen, either at the top of the cabinet or at...
Эта инструкция также подходит к моделям:Вентиляторы - 5980410 (264.36 kb)