Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
Some seating positions in your vehicle may not be safe for this infant restraint. Some vehicles do not have any seating positions that can be used safely with the infant restraint. If you are not sure where to place the infant restraint in your vehicle, consult your vehicle owner’s manual or Graco Children's Products Inc., 1-888-224-6549. • Whenever possible, secure the infantrestraint in the center position of theseat directly behind the front seats ... An adult should ride in the rear seat to watch the child. If the driver is the onlyadult present, a child may need to ride in the front seat. BUT ONLY if there is no passenger-side air bag and all of the othervehicle seat and seat belt requirements listed are met. .. • NEVER place this infant restraint in a .. vehicle seating location that has an air bag ... See “3.1 Warnings for Use as Infant Restraint”, p.14. 19 • The VEHICLE seat must face forward. • DO NOT use infant restraint on vehicle seats with seat backs that will not lock in an upright position. DO NOT use seats that can fold down without having to release a lock or latch of somekind. These seats can fly forward and strike the child in a suddenstop or crash. 4.2 Vehicle Seat Belt Requirements 20MANY SEAT BELT SYSTEMS ARE NOT SAFE TO USE WITH THE INFANT RESTRAINT. THE VEHICLE SEAT BELT MUST BE DESIGNED TO HOLD THE INFANT RESTRAINT TIGHTLY AT ALL TIMES. Pay careful attention to these systems; some of the seat belts thatare not safe to use look very much like seat belts that are safe touse. If you are unsure, consult your vehicle owner’s manual or Graco Children's Products Inc., 1-888-224-6549. 4.2.1 UNSAFE Vehicle Belt Systems DO NOT use any of the following systems to secure the infant restraint. • Lap Belts with Emergency Locking Retractor (ELR) This lap belt stays loose and can move until it locksin a crash or sudden stop. • Combination Lap/Shoulder Belt with RetractorEach strap has a retractor at one end and isattached to the latch plate at the other end. • Passive Restraint - Lap Beltwith Motorized Shoulder Belt • Passive Restraint - Lap orShoulder Belt Mounted on Door DO NOT use vehicle belts that are attached to the door in any way or that move along a track toautomatically surround the passenger when the door is closed. • Lap Belts Forward of Seat Crease 21 4.2.2 SAFE Vehicle Belt Systems THE FOLLOWING BELT SYSTEMS CAN BE USED WITH YOUR INFANT RESTRAINT, IF the seat location meets all other requirements of these instructions and those in your vehicle owner's manual. • Lap Belts - Manually Adjusted When buckled, the belt is tightened manually by pulling on the excess belt while pushing down hard on the infant restraint. • Lap Belts with AutomaticLocking Retractor (ALR) The automatic locking retractor will not permit the lap belt to lengthen once it is buckled. Tighten the belt by feeding the belt back into the retractor while pushing down hard on the infant restraint. • Combination Lap/Shoulder Beltwith Locking Latch Plate Once it is buckled, this type of belt has a latchplate that will not allow the lap portion of the belt to loosen. Belt is tightened by pulling hard on the shoulder portion of the vehicle belt while pushing down hard on the infant restraint. 22 • Combination Lap/ShoulderBelt with Sliding Latch Plate This belt has a latchplate thatslides freely along the belt. This belt MUST be converted to prevent movement of the lap portion of the belt. You must use the locking clip provided with the infant restraint, unless your vehicle's seat belt Locking clip can be converted in another way as described in your vehicle owner's manual. To Install Locking Clip: 1. Tighten the buckled belt by pushing down hard on the infant restraint and pulling hard on the shoulder belt. 2. While pushing down on infant restraint, pinch the two straps together behindthe buckle tongue. Unbuckle the beltwithout allowing it to slip. 3. Connect lap and shoulderbelts with locking clip asshown . and ... 4. Rebuckle belt. Check that lap belt does not move bypulling and pushing hardon infant restraint. If belt . inch .. .. loosens or lengthens, Locking clip goes here, repeat procedure. 1/2 inch from the buckle 23 5.0 Using Infant Restraint 5.1 Positioning Harness Straps FAILURE TO PROPERLY ADJUST THE HARNESS STRAPS FOR YOUR CHILD INCREASES THE RISK OF SERIOUS INJURY OR DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP OR CRASH. The harness straps must be properly adjusted to fit your child according to the following instructions. 1. Remove infant restraint from base and rotate handle down to sitting position. See “2.3 Removing and Attaching Base” and “2.4 Adjusting Handle”, p. 11. 2. Place child in infant restraint as shown ... 3. Determine which pair of harness slots are even with or just below your child’s shoulders ... DO NOT use upper harness slots if theyare above your child’s shoulders. Theywill not hold a small child securely in asudden stop or crash. 4. If the harness straps must be adjusted: remove child fro...
Эта инструкция также подходит к моделям:Велосипеды - 6111 (3.52 mb)
Велосипеды - 6113 (3.52 mb)
Велосипеды - 6114 (3.52 mb)