Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
See “2.3 Removing and Attaching Base” and “2.4 Adjusting Handle”, p. 11. 2. Place child in infant restraint as shown ... 3. Determine which pair of harness slots are even with or just below your child’s shoulders ... DO NOT use upper harness slots if theyare above your child’s shoulders. Theywill not hold a small child securely in asudden stop or crash. 4. If the harness straps must be adjusted: remove child from infant restraint and follow directions for your type of harness system: .... 5.1.1 3-Point Harness - p. 25 Use harness slots even with or just below 5.1.2 5-Point Harness - p. 26 child’s shoulders 24 5.1.1 3-Point Harness 1. From back, push harness anchorbuckle back through harness slot. If necessary, from front, use harness strap to pull buckle from slot ... Harness tightener buckle 2. Reinsert harness anchor buckle in the appropriate slot ... 3. From back, remove harness strap fromharness tightener. If necessary, from front, use harness strap to pull strap from slot. . 4. Reinsert strap in the appropriate slot. Thread strap through tightener exactly as shown ... 5. SAFETY CHECK: a) CHECK that straps are not twisted; . b) CHECK that straps are secure: pull on harness straps from front. c) CHECK that harness anchor buckle is snapped flat against back as shown ... .. Harness anchor .. 25 5.1.2 5-Point Harness 1. Depress the harness adjustment buttonunder the seat flap ... Pull the shoulder straps out to loosen the harness . 2. Behind seat, remove the ends of the two shoulder straps from the metal junctionplate ... 3. From front, pull straps through theharness slots and then reinsert them Harness adjustment button through the appropriate slots. 4. Behind seat, push both shoulder straps UNDER owner’s manual pocket and out the bottom. .. 5. Reassemble the strap ends onto themetal junction plate ... Follow the appropriate instructions for a smalleror larger baby on the following page. .. 6. SAFETY CHECK: After the harness has been completely reinstalled, a) CHECK that harness straps are not twisted in front or back. b) CHECK that straps are secure by pulling on them. 26 FOR SMALLER BABY: Use the lower harness slots . (if they are even with or just belowyour child’s shoulders) and the upper strap loops ... The ends of the straps must hang in front of the metal plate as shown in .., not as shown in ... ...... CHECK that the loops are completelywithin junction plate slots ... CHECK that straps are secure by pullingon them. .. FOR LARGER BABY: Use upper harness slots and the end strap loops ... CHECK that the loops are completely within junction plate slots ... CHECK that straps aresecure by pulling onthem. 27 .... 5.2 Securing Child in Infant Restraint Failure to properly secure your child in the infant restraint/carrierincreases the risk of serious injury or death from suffocation orfalls, or in the event of a sudden stop or crash. Even when usedonly as a carrier, make sure the harness straps are properlysecured. 1. 2. 3. Place your child in the infantrestraint as shown in .., not ... Pull the harness strapsdown over your child. 4. Follow directions for yourharness: 5.2.1 3-Point Harness: p. 29 5.2.2 5-Point Harness: p. 30 Move infant restraint handle to sitting position (see page 11). Open harness clip bysqueezing both sides andunbuckle as shown ... .. OR .... 28 5.2.1 3-Point Harness .. 5. Buckle harness to the latch between child’s legs. Make sure thatyou hear a “click.” DO NOT use the infant restraint if the harness does not latch in place. Call Graco at 1-888-224-6549. 6. From the back, pull strap throughharness tightener to tighten the strapsas shown ... CHECK that both strapsare flat and tight on child’s shoulders. 7. Snap harness clip pieces together ... Position harness clip in middle of chest,. level with armpits and away from theneck ... 8. SAFETY CHECK: a) CHECK that harness straps are not twisted. b) CHECK that the harness is snug. You should not be able to insert more than one finger between the harness and your child’s shoulder ... .. 29 5.2.2 5-Point Harness 5. Insert the two buckle tongues into the harness buckle on thecrotch strap. Make sure that you hear each tongue click intothe buckle. DO NOT use the infant restraint if the harness does not latch in place. Call. Graco at 1-888-224-6549. 6. Snap harness clip pieces together ... 7. Pull on harness adjustment strap to tightenstraps as shown ... CHECK that both straps are flat and tight on shoulders. 8. Position harness clip in middle of chest, level with armpits and away from theneck ... 9. SAFETY CHECK: a) CHECK that harness straps are not twisted. b) CHECK that the harness is snug. You should not be able to insert more than one finger between the harness and your child’s shoulder ... .. .. 30 5.3 Installing the Infant Restraint/Base You must carefully follow the instructions provided by your vehiclemanufacturer, in addition to the information in this manual. Be sure you have read and understood section 4, “Infant Restraint Location” on...
Эта инструкция также подходит к моделям:Велосипеды - 6110 (3.52 mb)
Велосипеды - 6113 (3.52 mb)
Велосипеды - 6114 (3.52 mb)