Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
PLEASE READ CAREFULLY AND STORE IN A SAFE PLACE. Congratulations! The Specialized bicycle you have chosen is among the finest of advanced composite products available in cycling. Carbon fiber is a very special material that requires particular care during assembly, storage and riding. This short form installation guide contains instructions and warnings, plus torque specifications. Please read the following instructions. If you have any doubt regarding your mechanical ability and/or installation of this product, visit your local authorized dealer. Specialized recommends that components be installed on the frame using a torque wrench, by a qualified mechanic. Please read the following Warnings. Because the failure to follow any Warning may result in a catastrophic failure of the frame, resulting in serious personal injury or death, this phrase may not be repeated in connection with each Warning. To ensure the best assembly possible and to prevent any damage to the components or frame, follow all torque specifications. Please refer to the specific owner’s manual for mating component’s correct torque specifications. If the mating component’s recommended torque exceeds the frame’s recommended torque, use the lower torque spec. Due to torque considerations, not all components will be compatible. The seat post is marked with a minimum insertion line, which is the minimum insertion required for the seat post to remain structurally safe. WARNING! Do not extend seat post above the minimum insertion line. Extension beyond the minimum insertion line can result in failure. HEADSET 12344351. Cone spacer/cap2. Compression ring3. Bearing seal4. Bearing5. Crown race46mmMindset48mmCampy Your Specialized frame does not require any head tube pre-installation preparation. All surfaces are already prepared from the factory, with the exception of greasing the cups. TARMAC: Use 42mm Campagnolo Standard compatible bearings. No tools are required for installation / removal of 42mm Campagnolo Standard MindSet bearings. ROUBAIX/RUBY: Use only Specialized 4mm MindSet bearing/cups. The bearing and cup are an integrated assembly specifically designed to fit Specialized frames using the MindSet Integrated Headset. INSTALLATION: Grease cups! Press the bearings in using the Specialized Integrated Headset Press Tool (9895-3045). This tool is compatible with the Park Headset Press and applies even pressure to the outer surface of the bearing to prevent damage. REMOVAL: Use a standard headset cup removal tool. Make sure the tool is evenly engaging the cup of the bearing before removal, and not against the head tube bearing inserts that are bonded into the frame. WARNING! Failure to follow the torque specifications in this installation guide will void the warranty, but most importantly may result in damage to the frame which may not be visible. If the frame is damaged, this can result in loss of structural integrity, which may result in serious personal injury or death. Bicycle components such as a handlebar, handlebar stem, seat post, saddle, brakes, all must be com...
Эта инструкция также подходит к моделям:Велосипеды - Tarmac (127.34 kb)