Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
CAUTION: The unit's power supply cord must be connected to a properly grounded and protected 120-volt outlet. Always use ground fault protection where required by the electrical code. WARNING: Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged, return the unit to an authorized service facility for examination, electrical or mechanical adjustment or repair. Product Dimensions and Specifications SAFETY INFORMATION Continued 12.5" 25.25" 20" Figure 1 - Heater Dimensions Frequency 60 Hz Heater Power 1500 W Heater Output 5000 BTUs Power Supply 120V; 15 Amp Grounded, Circuit Note: A dedicated power supply circuit is recommended for the unit but not required. Additional electrical appliances on the same circuit may exceed the current (amperage) rating for that circuit. If after the installation of your unit, the circuit breaker trips or the fuse fails on a repeated basis, then a dedicated circuit will likely be required. Any new wiring must be done in compliance with local and national codes and other applicable regulations in order to reduce the risk of fire, electric shock or other injuries. Therefore, it is strongly recommended that you hire a licensed electrician to complete any such work. Grounding instructions This stove is for use on 120 volts. The cord has a plug as shown in Figure 2. An adapter is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding plug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available. Adapter Grounding Pin Figure 2 - Grounding Methods Operating Instructions Once the unit has been properly connected to a ground electrical outlet, it is ready to operate. Note: Ensure the circuit breakers for power supply are turned on. Control Panel Operation Controls are located on the back of the unit (see Figure 3). 1. Main ON/OFF Power Switch: This switch is located at the furthest right corner on the control panel when looking at the back of the unit. Turn the switch to ON and unit will be ready to operate. The "|" indicates ON and "O" indicates OFF. IMPORTANT: Once you turn the main switch to the ON position, the remote control can no longer be used. In order to use the remote control, you must keep the main ON/OFF switch in the OFF. 2. Ember Control Dial: There is a divided circle under this dial. After you turn the Main Power switch to the ON position, turn the Ember Control Dial to desired setting. This dial controls the intensity of the lighting under the ember bed. 3. Flame Control Dial: There is a flame picture under this dial. Turn this dial to adjust the flame intensity. 4. Heater Switch and Control Dial: The heater switch has a sun directly below it. To turn the heater on, flip Heater Switch to ON position ( "|" indicates ON and "O" indicates OFF). The Control Dial has a thermometer below it. Turn d...
Эта инструкция также подходит к моделям:Варочные панели - CGESBMRA (718.29 kb)
Варочные панели - CGESBMRA (718.29 kb)
Варочные панели - CGESBMRA (718.29 kb)
Варочные панели - CGESBMRA (718.29 kb)