Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
11. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, the cord should be No. 14AWG minimum size witha grounding plugandrated not lessthan 1875 WATTS. WARNING:Improperinstallation, adjustment, alteration, service or maintenance can cause injuryorpropertydamage.Refer tothismanual.Forassistanceor additional information, consult a qualified installer. WARNING: Risk of fire - keep combustible material away from the front of the heater. Keep electrical codes, drapery and other furnishingsat least 3 feet fromthe front and sides of electric stove. WARNING: Servicing should be done only while the heater is disconnected from the power supply circuit. CAUTION: For lower lamps (ember bed) and flame generation lamps, replace only with lamp type GX6.35 rated 120V, 35W max. For upper lamps (top contrasting light) replaceonlywithlamptypeGX6.35, rated 120V , 20W max. 117191-01A SAFETY INFORMATION Continued 12. Always disconnect the unit from the power supply before performing any cleaning, light bulb replacement, maintenance, relocating the heater or when the unit is not in use for long periods of time. 13. When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage the unit. LISTING APPROVALS This heater has been tested in accordance with the CSA Standards for fixed and location-dedicated electric room heaters in the United States. All components are UL or CSA safety certified. If you need assistance during installation, please contact your local dealer or the DESAHeating Products Technical Services Department at 1-866-672-6040. UNPACKING AND TESTING THE UNIT Carefully remove the unit from the box. Prior to permanently installing the unit, test to make sure the unit operates properly by plugging the power supply cord into a conveniently located 120-volt grounded outlet. CAUTION: The unit's power supply cord must be connected to a properly grounded and protected 120-volt outlet. Always use ground fault protection where required by the electrical code. WARNING: Do not operate the unit if it is damaged or has malfunctioned.Ifyoususpectthe unit is damaged, return the unit to an authorized service facility for examination, electrical or mechanical adjustment or repair. PRODUCT DIMENSIONS & SPECIFICATIONS 12.5" 19.5" 19.625" Figure 1 - Heater Dimensions Model: CGESBM Frequency 60 Hz Heater Power 1500 W Heater Output 5000 BTUs Power Supply 120V; 15 Amp Grounded, Circuit Note: A dedicated power supply circuit is recommended for the unit but not required. Additional electrical appliances on the same circuit may exceed the current (amperage) rating for that circuit. If after the installation of your unit, the circuit breaker trips or the fuse fails on a repeated basis, then a dedicated circuit will likely be required.Any new wiring must be done in compliance with local and national codes and other applicable regulations in order to reduce the risk of fire, electric shock or other injuries. Therefore, it is strongly recommended that you hire a licensed electrician to complete any such work. 117191-01A GROUNDING INSTRUCTIONS This stove is for use on 120 volts. The cord has a plug as shown in Figure 2. An adapter is available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available. To decrease the desired temperature, turn the temperature dial counter clock...
Эта инструкция также подходит к моделям:Варочные панели - CGESBM (375.22 kb)
Варочные панели - CGESBM (375.22 kb)
Варочные панели - CGESBM (375.22 kb)
Варочные панели - CGESBM (375.22 kb)