Оценок - 0, средний балл: 0
(
)
)
|
Фрагмент инструкции
• Do not allow pans to boil dry. This can damage the pan, element and/or the cooktop. • Never cook food directly on the glass. • Avoid placing a wok support ring, trivet or other metal stand on the glass surface. • Do not use the glass surface as a cutting board. • Do not slide cookware across the cooking surface; it may scratch the glass. • Do not place wet pans on the glass surface. BEFORE USING THE COOKTOP FOR THE FIRST TIME Cooktop Operating Instructions Retained Heat The glass cooking surface retains heat and stays hot after the element(s) have been turned off. The retained heat may be used to hold foods at serving temperatures for a short time. General Operation of Cooktop The cooktop uses touch pads and a magnetic dial to operate the cooktop. When touching the glass of a touch pad, such as an element or function pad, use the flat part of the finger and touch the center of the pad. A beep will sound when touching any of these pads. mTw isT Dial The cooktop uses a mTwisT magnetic dial to select the desired heat setting. The mTwisT dial is held onto the cooktop by a strong magnet and automatically positions itself in the center of the dial location when placed on the cooktop. The dial can be set to beep as it turns or to be silent as it turns. The default setting is silent. To activate dial sound: 1. Turn on all cooking zones to level 3 (See Cooktop Operation Instructions for details). 2. Turn each cooking zone off, one at a time, in the following order: 1. Front Right 2. Rear Right 3. Rear Left 4. Front Left 3. Press and hold the power key until it beeps (about five seconds). To turn knob sound off , repeat steps 1, 2 and 3 above. Panel Lock If the knob is removed from the cooktop while the cooktop is operating, the elements turn off. The cooktop cannot be used again until the knob is returned. This is known as panel lock. The panel lock can be set to activate immediately upon removal of the knob or after a ten second delay. The default setting is the ten second delay. To turn the delay off : 1. Turn all cooking zones to level 5 (See Cooktop Operation Instructions for details). 2. Turn each cooking zone off, one at a time, in the followng order: 1. Front Right 2. Rear Right 3. Rear left 4. Front Left 3. Press and hold the power key until it beeps (about five seconds). To activate the delay , repeat steps 1, 2 and 3 above. Element ‘ON’ Indicator Light The area above the element touch pad being used will show the cook setting when the element is on. When the element is turned off, the hot surface indicator comes on in this area. (See Hot Surface Indicator Light below) . Hot Surface Indicator Light Each element features a hot indicator light to show when the cooking surface is too hot to touch. A letter H will appear above the element touch pad. The light remains on until the cooking area has cooled to a safe- to-touch temperature. If a hot surface light is on, use caution when working or cleaning around the cooktop as the cooktop is still hot. PAGE 4 NES Cooktop Use and Care Manual Cooktop Operating InstructionCooktop Operating Instructions The Elements / Setting the Controls Radiant Elements Bosch UltraSpeed TM radiant elements use a wire ribbon located under the ceramic glass surface to provide the heat for cooking. These radiant elements will cycle on and off by design (see Temperature Limiters , below.) There are 9 heat setting posi...
Эта инструкция также подходит к моделям:Варочные панели - NES732UC/02 (1.81 mb)
Варочные панели - NES735UC/01 (1.81 mb)
Варочные панели - NES735UC/02 (1.81 mb)
Варочные панели - NES736UC/01 (1.81 mb)