Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
Note: if only the left rear surface Burner is needed, follow the instructions provided below. Operating only the Left rear Gas Surface Burner 1. Place cooking utensil centered over the left-rear surface Burner Grate. 2. Push the left rear surface control knob in and turn counterclockwise out of the OFF position (See Figure). 3. Release the knob and rotate to the LITE position. Note: All electronic surface ignitors will spark at the same time. However, only the [eft rear Burner will ignite. 4. Visually check that the left-rear burner has lit. Adjust the flame size by turning the control knob between the first Hi and LO settings (See Figure). DO NOT cook with the surface control knob in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position). 10 General Care & Cleaning Cleaning Various Parts of Your Cooktop Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE DIFFICULTY AND EXTENT OF A MAJOR CLEANING LATER. Surfaces How to Clean Aluminum (Trim Pieces) & Use hot, soapy water and a cloth or paper towel. Dry with a clean cloth. Vinyl Painted and Plastic Control For general cleaning, use hot soapy water and a cloth. For more difficult soils and Knobs, Body Pieces, and built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to DecorativeTrim 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials; they can scratch or dull the finish. Control Panel Wipe the control panel clean after each use. Before cleaning the control panel, turn all controls to OFF and remove the control knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy water and a cloth. Be sure to squeeze excess water from the cloth before wiping the panel; especially when wiping around the controls. Excess water in or around the controls may cause damage to the appliance. To replace knobs after cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place. Stainless Steel, Chrome Clean with hot, soapy water and a dishcloth. Rinse with clean water and cloth. Do Decorative Trim not use cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel. Always be sure to rinse the cleaners off from the surface as bluish stains may occur during heating that cannot be removed. Porcelain Enamel Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 Burner Grates, Burner Pans solution of clear water and ammonia, ffnecessary, cover difficult spots with an (some models), Burner Rings ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a (some models), Cooktop damp cloth, and then scrub with a soap-filled scouring pad. Ri...
Эта инструкция также подходит к моделям:Варочные панели - 790.31 (1.41 mb)
Варочные панели - 790.3101 (1.41 mb)
Варочные панели - 790.31 (1.41 mb)
Варочные панели - 790.3101 (1.41 mb)