Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. FOR YOUR SAFETY: — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. — Installation and service must be performed by a qualified installer, service agency or the gas supplier. Cooktop Dimensions Cooktop Cutout Dimensions * 30" min. for unprotected cabinet 24" min. for protected surface A B C D E F 30" Min.* (76.2 cm) Min.* L M Figure 1 MODEL A. B. WIDTH C. DEPTH CUTOUT DIMENSIONS F. DEPTH BELOW COOKTOP* L (Min.) M (Min.) D. LENGTH E. WIDTH MIN. MAX. MIN. MAX. 30" Models 30 (76.2) 21 . (54.6) 3 1/8 (7.9) 26 5/8 (67.6) 26 7/8 (68.3) 19 (48.3) 19 3/8 (49.2) 5 (12.7) 2. (7) 2. (5.7) All dimensions are in inches (cm). * Dimension F is for clearance under cooktop for gas connection. NOTE: Wiring diagram for this appliances is enclosed in this booklet. Only some models are available in Canada. P/N 318201451 (0711) Rev. F English – pages 1-7 Printed in United States Espanol – paginas 8-14 Francais – pages 15-21 Wiring Diagram - pages 22 GAS COOKTOP INSTALLATION INSTRUCTIONS A Min. Dimensions J is the Minimum Distance Required Between Rear of Cooktop and Adjacent Combustible Surfaces.18" Min. (45.7cm Min.) Clearance 24" (61 cm) Dimension H is the Minimum Clearance Required From Right Side of Cooktop To Adjacent Combustible Dimension K is the Minimum Clearance Adjacent Combustible Drawers Cannot Be Used With This Cooktop Since Burner Box Extends 3" (7.6 cm) Below Surface of Countertop. 13" (33 cm) Max. Depth For Cabinet Installed Above Cooktop. Required From Left Side of cooktop To Surface. 30" (76.2 cm) Min. Clearance Between the Top of the Cooking Platform and Unprotected Wood or Metal Cabinet 24" (61 cm) Min. when Bottom of Wood or Metal Cabinet is Protected by Not Less Than 1/8" Flame Retardant Millboard Covered with Not Less Than N0.28 MSG Sheet Steel, 0.015" (0.04 cm) Stainless Steel, 0.024" (0.06 cm) Aluminum or 0.020" (0.05 cm) Copper. Surface. To eliminate the risk of surfaces, cabinet storage space located above the cooktop should be avoided. If cabinet storage is provided, risk can be reduced by installing a range hood that projects horizontally a minimum of 5" (12.7 cm) beyond the bottom of the cabinets. burns or fire by reaching over heated MODEL H J K 30" Models 4" (10.2 cm) 1 1/2" (3.8 cm) 6" (15.2 cm) Figure 2 – COUNTERTOP CUTOUT OPENING 2 GAS COOKTOP INSTALLATION INSTRUCTIONS Important Notes to the Installer 1. Read all instructions contained in these installation instructions before installing the cooktop. 2. Remove all packing material before connecting the electrical supply to the cooktop. 3. Observe all governing codes and ordinances. 4. Be sure to leave these instructions with the consumer. 5. Note: For operation at 2000 ft. elevations above see level, appliance rating shall be reduced by 4 percent for each additional 1000 ft. Important Note to the Consumer Keep these instructions with your Use and Care Guide for future reference. IMPORTANT SAFETY INSTRUCTIONS Installation of this cooktop must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code ANSI Z223.1—latest edition in the United States, or in Canada, with the Canadian Fuel Gas Code, CAN/CGA B149 and CAN/CGA B149.2. This cooktop has been design certified by American Gas Association (A.G.A.). As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find them in the Use and Care Guide, read it carefully. • Be sure your cooktop is installed and grounded properly by a qualified installer or service technician. • This cooktop must be electrically grounded in accordance with local codes or, in their absence, with the National Electrical Code ANSI/NFPA No. 70—latest edition in the United States, or in Canada, with the Canadian Electrical Code, CSA C22.1 Part 1. • The burners can be lit manually during an electrical power outage. To light a burner, hold a lit match to the burner head, then slowly turn the Surface Control knob to LITE. Use caution when lighting burners manually. • Do not store items of interest to children in the cabinets above the cooktop. Children could be seriously burned climbing on the cooktop to reach items. • To eliminate the need to reach over the surface burners, cabinet storage space above the burners should be avoided. • Adjust surface burner flame size so it does not extend beyond the edge of the cooking utensil. Excessive flame is hazardous. • Never use you...