Оценок - 3, средний балл: 3
(
)
)
|
Фрагмент инструкции
only). Warning : this appliance must be earthed. Important : the wires in this lead are coloured in accordance with the following codes : - Green and yellow : earth - Brown : live - Blue : neutral. • Connect the green/yellow wire to the terminal in the plug marked ”E” or by the earth symbol or coloured green and yellow. • Connect the brown wire to the terminal in the plug marked ”L” or coloured red. • Connect the blue wire to the terminal in the plug marked ”N” or coloured black. A 13 amp fuse should be fitted when the appliance is connected to a BS 1363A plug. Seek professional advice if unsure of the correct procedure for the above. Important : If the electrical cord of this appliance is damaged or shows signs of wear, it must only be replaced by an authorised Tefal Service Centre (see section After Sales Service). Green and yellow or greenE Blue or black Brown or red Fit correct fuse Use cable gripper N L • Your steam generator is an electric appliance. It should be used in normal usage conditions. • Your generator is fitted with 2 safety systems : -a thermal fuse for preventing any ove- rheating. -an exhaust valve incorporated into the boiler cap, in order to prevent excess pressurisation; in the event of a malfunction, the cap allows steam to escape. Caution: if the safety cap is dropped or knocked heavily, the valve may get damaged. In this case, have the boiler cap replaced in an Approved Service Centre. • Always connect your steam generator to a power supply where the voltage is between 220 and 240 V. Any connec- tion error may cause irreversible dama- ge to the steam generator and will can- cel the guarantee. • This iron must be plugged into an earth socket. If your are using an extension lead, ensure that it is the bipolar type (10A) with an earth conductor. • If the power cord is damaged, it must be replaced immediately by an Approved Service Centre to avoid danger. • Caution : the soleplate of your iron may reach very high temperatures, which can cause burns. If your iron is placed for a few moments on the iron rest plate, this plate may also reach very high temperatures. In this case, do not touch either the iron soleplate or the iron rest plate until the iron has cooled down. • Caution : your steam generator allows you to iron with a considerable steam output. This steam is hot : it can cause burns. • Handle your iron with great care, par- ticularly if your are ironing in an upright position. • Always leave your generator out of reach of the children. Never leave it unattended while it is switched on. • Always disconnect your steam gene- rator : -before filling or emptying the boiler. - before cleaning your generator. - after each use. • In order to unscrew the boiler cap, always ensure that: - your generator is cold (that is, discon- nected for over an hour). -there is no more pressure in the boi- ler. In all other cases, never attempt to uns- crew the boiler cap while it is in use : the strong pressure could cause burns. • Never immerse your steam generator in water or any other liquid. While rin- sing out the boiler, never fill it directly under the tap. Never hold the generator base set under the tap. • Should the steam generator be drop- ped or severely knocked, or if you obser- ve any irregularity in its operation, have your generator inspected by a qualified engineer at an authorised service centre, where it will be restored to good wor- king order. • If the boiler cap is lost or worn out, have it replaced with the same model. 1 2 2 3 1 2 3 Safety notes Steam ironing silk cotton Linen Never dismantle your iron: always take it to an Approved Service Centre. Where to install your steam generator? You can install the generator : • on the iron rest plate of your ironing board (if it is large enough) OR • beside your ironing board, on a heat-resistant stand Your steam generator should be located at the height of your ironing board or below it. Always place the generator on a firm surface, either while ironing or when filling the boiler. How to use your generator First of all fill the boiler : What kind of water should I use? • Caution : never use demineralised water from batteries, refrigerator condensation, water from a condenser clothes dryer or water from a softener. All these kinds of water harm the steam generator only use untreated tap water. • If you have a water softener : take the water prior to the softener, or else take care to empty the boiler regularly (see “Maintaining your generator”). • For safety reasons, never put additives (perfume, finish, fragrance oils, etc.) in the boiler. 1 2 3 4 5 6 Place your generator on a horizontal stand. Check that your generator is disconnected and cold. Unscrew the boiler cap. Using a water jug, fill with one litre of untreated tap water. Fill the boiler, taking care that the water does not spill over. If this occurs, remove the excess water. Replace the boiler cap, screwing on tightly. Using your generator : 1 Connect your generator to an “ea...