Installing the switch
12 Insert the switch into the library and
attach it to the rack
9 Attach the brackets to the new switch
11578
Use a #2 Phillips screwdriver.
10 Plug the power cord into the back
of the switch
11581
Route the power cord so that it can reach to the power strip on the left
11579
side of the cabinet. Use a #2 Phillips screwdriver to tighten the screws.
11 Install the clip nuts in the rack
13 Plug the cables into the switch
If you are replacing the switch, skip this step because the clip nuts wil
already be installed.
42
41
11574
NOTE:
40
If an LTO4 tape drive is not already installed, follow the
instructions on the tape drive installation poster to instal it.
11580
Install the clip nuts at the 41C position in the rack.
If the switch was previously installed, use the labels on the cables or
the note that you wrote to reconnect the cables exactly as they were
connected before. If you are installing the switch for the first time, plug
an Ethernet cable from the MGMT port on each LTO4 tape drive to a
numbered port on the switch. HP recommends that you connect the
tape drives in order starting with connecting the top tape drive to port
1. LTO3 tape drives do not connect to this switch.
Page 3

---

...

Эта инструкция также подходит к моделям:
Устройства обработки данных - HP EML 103e Tape Library (1.39 mb)
Устройства обработки данных - HP EML 245e Tape Library (1.39 mb)
Устройства обработки данных - HP EML Base Library (1.39 mb)
Устройства обработки данных - HP EML E-Series 103e Base Tape Library (1.39 mb)