Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
51
54 Configure the library
If this is the first time the library has been powered on
after delivery, or if a new interface controller was
installed, configure the interface controller so that it is
3
recognized by the Interface Manager card.
Wait several seconds and then turn on the power switch
again.
NOTE: The library requires up to fifteen minutes to
initialize and do an inventory. While the library
is doing an inventory, continue with the next step.
After the inventory completes, use
the touch screen (called the
Operator Control Panel or OCP) on
52
the front of the library to configure
Install the software
the library. Do the following
commands:
Configuration > Library Configuration > Change
Password
The library ships with a null password. Passwords
must be set to exactly eight characters consisting of
the numbers 0 through 9 and the period character.
Configuration > Library Configuration > Configure
Load Ports
This command shows the number of installed load
ports and enables you to toggle between using
each for import/export or for storage. Configure it
as a load port to move tapes in and out of the
library. Configure it as slots to increase the number
of storage slots in the library. Changing a load port
Install HP StorageWorks Command View TL on the
configuration will cause a library reboot.
management station. Install this software from the
Configuration > Library Configuration > Change
included CD.
Network Settings
This configures the network settings for the Interface
Manager card, which can be set automatically
53
using DHCP (the default) or manually using a static
IP address. Use the Address Config: button to
toggle between these two options. If you are setting
the network addresses manually, set each address
element separately.
Install HP StorageWorks Library and Tape Tools (L&TT)
on the management station. Download this software
Configuration > Library Configuration > Configure
from http://www.hp.com/support/tapetools.
Barcode Reporting Formats
This command defines how bar codes are displayed
on the OCP and sent to the host. Bar code reporting
can be configured as six to eight characters and left
or right aligned. If you choose six characters with left
alignment, any characters after the six are truncated.
If you choose six characters and right alignment,
only the last six characters are shown with the
beginning characters truncated.
Configuration > Library Configuration > Configure
Inventory Mode
This command allows you to require bar codes on
tape cartridges, or to make them optional. Requiring
bar codes significantly shortens inventory time.
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP EML 103e Tape Library (3.45 mb)
Устройства обработки данных - HP EML 245e Tape Library (3.45 mb)
Устройства обработки данных - HP EML Base Library (3.45 mb)
Устройства обработки данных - HP EML E-Series 103e Base Tape Library (3.45 mb)