Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
ADD-ON KIT WARNING: Read and follow all directions for each step to insure proper asembly of this product. ASSEMBLY INSTRUCTIONS CLASS H PART # 7016801 REV. B Version: 216101 Revision: 03/23/01 STEP 6: • Assemble the WEIGHT STACK PIN to the 20 HOLE WEIGHT STACK SHAFT as shown. • Screw the WEIGHT STACK CABLE into the 20 HOLE WEIGHT STACK SHAFT of the HEAD PLATE until the CABLE slightly pulls on the HEAD PLATE. • TIGHTEN cable jam nut securely! • CAREFULLY assemble and SECURELY tighten any previosly removed or loosened bolts in the TOP BOOM to allow the GUIDE RODS to be secured. Refer to the GYM ASSEMBLY INSTRUCTIONS. Thank you for purchasing the Parabody 216101 50 LB. ADD-ON K3T, If unsure of proper use of equipment, call your local LifeFitness distributor or call the Parabody customer service department at (800) 328-9714. 5 PARTS LIST KEY PART# DESCRIPTION QTY KEY PART# DESCRIPTION QTY 1 6939201 WEIGHT PLAIE 5 3 6978101 WEIGHT STACK LABEL 1 2 7095801 WEIGHT STACK SHAFT 1 4 6382301 WEIGHT PLATE BUSHINGS (10 CT) 1 • Insert two WEIGHT PLATE BUSHINGS (4) into each of the five WEIGHT PLATES (1) as shown in FIGURE 1. 2 STEP 2: • Unscrew the WEIGHT STACK CABLE from the 15 HOLE WEIGHT STACK SHAFT as shown in FIGURE 2. • Remove the WEIGHT STACK PIN from the 15 HOLE WEIGHT STACK SHAFT as shown. STEP 3: » CAREFULLY remove or loosen bolts in the TOP BOOM to allow the GUIDE RODS to be tilted. Refer to the GYM ASSEMBLY INSTRUCTIONS. TV.l the GUIDE RODS back and remove the SHAFT OLLARS, HEAD PLATE ASSEMBLY, fifteen WEIGHT R. u ES.; wc WEIGHT STACK CUSHIONS, two 3/4" ‘ASHERS, and two WEIGHT STACK SPACERS as shown riGlVRi.' 3. (NOTE; Please discard the two 3/4” V-r tttSEBS, siwt the twa WEIGHT STACK SPACERS.) 3 STEPS: • Insert She two GUIDE RODS through the two WEIGHT STACK CUSHIONS into the base as shown is FIGURE 5. Lubricate the GUIDE SODS with a silkor* or teflon spray that is available at most hardware stores. • USING EXTREME CARE, slide the live new WEiGHT PLATES (1) and the previous fifteen WEIGHT PLATES down over the GUIDE RODS onto the WEIGHT STACK CUSHIONS. (NOTE: Make sure that the key holes of the WEIGHT PLATES all face the same way.) • Carefully slide the new HEAD PLATE ASSEMBLY and the SHAFT COLLARS down over the GUIDE RODS onto the weight stack as shown in FIGURE 5. STEP 4; • Remove the E-RING and the old WEIGHT STACK SHAFT from the HEAD PLATE. (NOTE: Please discard the old WEIGHT STACKSHAFT.) • Slide the new 20 HOLE WEIGHT STACK SHAFT (2) thru the hole in the HEAD PLATE and lock in place using the previously removed E-RING as shown in FIGURE 4. 4...