Оценок - 2, средний балл: 2.5
(
)
)
|
Фрагмент инструкции
The program being played will be repeated 16 times, after which normal playback resumes. . When the “7 stop” key is pressed, playback stops and the one-program repeat is cancelled. Slow blinking Quick blinking Lights Rewind playback Rewinds tape to the beginning and restarts playback from there. Cassette deck only Press the “3 fwd “ or “2 rev ” key simultaneously with the “1“ or “A” key. fwd rev function indicator Dolby NR B-type rev.modecrlspause C-typereverseforward direction During playback (Slow blinking) During rewinding (Quick blinking) CASSETTE Press simultaneously During forward playback (while 3 is blinking) Press simultaneously During reverse playback (while 2is blinking) NotesNotes The DPSS may not function normally with the following kinds of tape. O Tapes containing several no-sound intervals of more than 4 seconds, such as conversation and talk tapes. O Tapes containing pianissimo sections, such as classical music tape. O Tapes in which large noise is recorded in blanks between programs. O Tapes containing blanks between programs that are shorter than 4 seconds. O Tapes recorded at low level. O Tapes recorded by cross-fade recording (in which the beginning of next program is overlapped on the end of previous program). OPERATIONS 44 Recording onto cassette tape 44 Recording onto cassette tape RD-VH7/X-VH7 (EN) CASSETTE DECK OPERATIONS 1. Load a tape in deck. 3. Select the source to be recorded. Note that this cassette deck cannot record onto Metal tapes. 2. Select the tape transport direction. 1Press the “3 fwd” or “2rev” key for the direction to be played . 2Press the “7 stop” key. O.T.E. Temporary stop during recording To end recording 11 22 55 O When the CD or MD input is selected while a disc has already been loaded in the source com- ponent, it starts to play; press the “7 stop” key to stop it immediately. The selected record- ing source is dis- played. TUNER (Radio broadcasting) Y CD ¤ MD TAPE (Recording is impossible.) AUX # input 33 reverseforward direction 33 44 0:0001 N.B.I PURE A TRACK Lights NoteNote fwdrev 22 Select an input source other than “TAPE” input. Insert the cassette straight into the insertion slot. Just push lightly and the cassette will be pulled automatically inside. O Normal (TYPE I) or high (TYPE II) tape selection is set automatically. O It is not recommended to use a 100-minute or longer cassette tapes, for these tapes are very thin and may easily cause troubles such as entangle- ment and cutting. O Remove tape slack before loading. Y O Avoid using tapes of which the label is not firmly adhered. Y Cassette deck Tape exposed side O Wind the tape to the position where recording is to be started. Recording onto cassette tape 45 Recording onto cassette tape 45 RD-VH7/X-VH7 (EN) Temporary stop during recording An unrecorded portion of about 4 seconds is Cassette deck only produced (auto recording mute) To enter record-pause mode from stop mode after leaving a non-recorded blank of about 4 seconds pause Lights Lights deck in stop mode. 2Press the “¦ rec/arm” key twice. O Press the “¦ rec/arm” to restart recording. Cassette deck only Press twice. recording 1Press the “7 stop” key to set the cassette rec/armpause To end recording Cassette deck recording Blinks for 4 sec. Lights then lights steadily. stop To enter record-pause mode from record mode after leaving a non-recorded blank of about 4 seconds Cassette deck only Press the “¦rec/arm” key during recording. rec/armpause recording Blinks for 4 sec. Lights then lights steadily. 4. Set the recording condition. Each press switch the modes as follows. 1Select the reverse mode. Dolby NRrev.mode 2Select the Dolby NR mode. 44 rev.mode Dolby NR B-typeC-type Lights Lights “O” lit ..... Tape stops after having recorded the two sides. Goes off..... Tape stops after having recorded one side of tape. “B-type” ... Tape is recorded using B Type. “C-type” ... Tape is recorded using C Type. Goes off..... Dolby NR is deactivated. 5. Start recording. 1Press the “¦ rec/arm” key. function indicator Dolby NR B-type rev.mode crls pause C-type reversedirection CASSETTE OPERATIONS rec/arm 55 Lights recording 2Play (or tune) the input source to be recorded. . The recording level is adjusted automatically when the “crls” function is used. y . Recording stops automatically when the tape side(s) to be recorded have been fully recorded. Recording onto cassette tape46 Recording onto cassette tape46 To restart recording Press the “1“ or “A” key in the middle of recording. Cassette deck only During reverse recording (while 2is blinking) During forward recording (while 3 is blinking) Return to the recording start position and stop there. RD-VH7/X-VH7 (EN) Tape stops after 2 sec. of transport. Tune to be re-recordedRecorded tune Re-recording Blank of 4 sec. or more . Recording is stopped, tape is rewound and stopped after leaving a non-recorded blank of about 2 seconds (provided that there is already a blank of 4 seconds or more before the point where th...
Эта инструкция также подходит к моделям:Ресиверы и усилители - RD-VH7 (1.45 mb)