All can be used, but the 75/25 mixture is recommended for general welding. For aluminum welding, use 100% Argon. Either type gas may be obtained at your local welding supply outlet. Secure cylinder in place on your welding machine or other support to prevent the cylinder from falling over. REGULATOR This regulator is designed to be used with straight Argon or Argon mix gas. A threaded adapter is needed if CO2 is used. An adapter is available at your local welding gas supplier to change between t

This includes any lost profits, lost savings, incidental damages, or consequential damages. AMX Corporation is not liable for any claim made by a third party or by an AMX Dealer for a third party. This limitation of liability applies whether damages are sought, or a claim is made, under this warranty or as a tort claim (including negligence and strict product liability), a contract claim, or any other claim. This limitation of liability cannot be waived or amended by any person. This limitati

INDIGLO® Night-Light - will backlight the display for easy viewing in the dark. Press any button to illuminate the light. (If no button is pressed after 5 seconds, the backlight will turn off.) note: if the thermostat shows a low Battery Warning, the backlight will not operate. follow the instructions on pages 42-43 to change batteries. 2. Filter change indicator - will flash after 400 hours of system use as a reminder to check or change your filter. Press and hold the Filter button for 3 second

This thermostat has been tested and found to comply with the requirements of the European Union for Electromagnetic Interference, Electromagnetic Immunity and Safety under the applicable EMI and Low Voltage Directives and Standards. This thermostat has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. This product generates and can radiate radio frequency energy. Due to its low power design, it is unlikely to interfere with radio

10-OFF OFFis displayed when the system is in the Off mode. 11-REMOTE REMOTE is displayed when the last command received by the thermostat was sent by a remote system. 12- Period Indicators MORN, DAY, EVE, or NITE is displayed when scheduled temperature changes are made by the thermostat programs. 13-HOLD HOLDis displayed when the system is in Hold mode. 5 FILTER REMINDER Your thermostat logs the amount of time your heating and cooling system has been running and gives you a reminder when it's ti

It offers programmability, stand-alone operation, and communications with automation systems, utility control systems, or personal computers over a Z-Wave network. The RC-80ZB is equipped with a “cool blue” backlight display. Electrical rating: 24 V; 3 A; 50/60 Hz Maximum current: 2 A on any circuit, 3 A total Thermostat operating current: less than 15 mA The following requirements must be observed for installation in Europe: CE 1. This equipment must be installed in accordance with National wir

As an EPA ENERGY STAR Partner, Home Automation, Inc. has determined that this thermostat meets the ENERGY STAR guidelines for energy efficiency. MAINTENANCE Your new thermostat is maintenance free. There is no battery to install or replace. If necessary, clean unit carefully with a mild soap solution on a soft cloth. 1 OPERATION To take advantage of all the benefits and features offered by your thermostat, we recommend that you start by becoming familiar with its operation. AUTO 4 ModeHold 2 Pro

When cooling, the thermostat will periodically run the cooling system to circulate the air and remove humidity when the temperature is close to, but not above the desired cool setting. Because of the PID algorithm and auto balance routine which monitors the performance of the HVAC system, the anticipator settings are automatic by default. However, the anticipator settings may be adjusted if desired. Heat Anticipator: This adjusts the tendency of the thermostat to turn the heating unit off before

The weekday MORN time will flash. 1. Use the arrow keys (U-U) to change the scheduled time for the displayed period (MORN, DAY, EVE, or NITE). :: A MORN DESIRED 2. Press the Prog key to advance to the next item. 3. Use the arrow keys (U-U) to change the desired cool setting. MORN COOL DESIRED :: A 4. Press the Prog key to advance to the next item. 5. Use the arrow keys (U-U) to change the desired heat setting. MORN DESIRED :: A HEAT 9 6. Press the Prog key to advance to the next period. 10 Repea

This thermostat has been tested and found to comply with the requirements of the European Union for Electromagnetic Interference, Electromagnetic Immunity and Safety under the applicable EMI and Low Voltage Directives and Standards. FCC This thermostat has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. This product generates and can radiate radio frequency energy. Due to its low power design, it is unlikely to interfere with ra