3 . 10) to install the bracket onto the speaker unit. 2. Use the cushion o install the bracket and speaker unit onto the installation surface. 3. Use the tapping screws (dia. 4 . 12) to secure the bracket onto the installation surface. AVERTISSEMENT INSTALLER LES HAUT-PARLEURS DANS UN ENDROIT QUI N’INTERFERERA PAS AVEC L’AIRBAG. 1. Fixer le support sur le haut-parleur a l’aide des vis autotaraudeuses (dia. 3 . 10). 2. Fixer le support et le haut-parleur sur la surface de montage a l’aide de la g

[ADJ] button • Shows the ADJUST MODE menu to change the settings. [MEMO] button • Shows the manual memory screen to store the station. • Press and hold this button for 1 second or longer to store the station in manual memory function. [PS] button • Press to perform preset scans. • Press and hold for 1 second or longer to perform the auto store operation. [DISP] button • Press this button to show the information on the screen. • Press and hold this button for 1 second or longer to switch the disp

Check that the set will not hamper operation of the shift stick before choosing the place of installation.(Figure 2) Dashboard 6. The main unit has mounting screw holes for NISSAN (N marks) and TOYOTA (T marks) vehicles. (Figure 5) TN T NN T Figure 5 Shift stick 182 mm 53 mmInstrument panel Rear fastening hole (of vehicle) HoleHole 2–Springs Outer escutcheon Special screw Rubber cap Stoppers Stoppers Screwdriver Universal mounting bracket Main Unit Note: Set the outer escutcheon so that its meta

Each time this button is pressed for 1 second or longer, the display mode is changed in the sequence shown below. Watching TV For normal 4:3 picture reception 1. Press the [BND] button to select TV1, TV2, VTR1 or VTR2. Each time the [BND] button is pressed, the setting is switched in the Depending on which mode is set, the shape of the picture will be distorted on the screen. sequence shown below. Full wide mode Cinema mode 62 TV1 F.WIDE 1 2 A.STORE 3 4 5 6 62TV1NORMAL 62 TV1 1. Press the [BN

If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery. 1. Press the [PWR] button. 2. The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode. 3. Press the [PWR] button to turn off the power for the unit. Standing up the liquid crystal panel 1. Press the [OPEN/CLOSE] button and the liquid crystal panel comes out and st

.. . .. ... IN-DASH WIDE 7" COLOR LCD TV ............................................................................................................................................................................................................................ .................................................................................................................................. ... 7.. .. LCD TV ... English English Owner’s manual Thank you for purchasing the Clarion TB741P/TB742P/TB7

stored in memory are cleared. The Reset button The remote controller does not work. Direct rays of the sun fall on the light-receptive part of the remote controller. When direct rays of the sun fall on the light-receptive part of the remote controller, it may not work. The batteries of the remote controller unit are dead or there is no battery in the remote controller unit. Check the batteries of the remote controller unit. English Owner’s manual TB741P/TB742P/TB743W 17 English Owner’s manual Pr

This owner’s manual is the TB851P/TB853W. . Please read this manual completely operating this equipment. . After reading this be sure to keep it in a handy g., glove compartment). . Check the contents of the card and keep it carefully with Contents 1. FEATURES ................................................................................................................... 2 2. PRECAUTIONS ..........................................................................................................