Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
(for 50”: 3 screws, for 55”/60”/65”: 4 screws) • Do not hold the neck when turning over the stand. B x 3 pcs. (for 50”) B x 4 pcs. (for 55”/60”/65”) Front Back of Stand Hole for screw [TC-P50ST50] [TC-P55ST50, TC-P60ST50, TC-P65ST50] Attach the Bracket to the protrusion of Neck. Make sure that the bracket is anchored before fixing the screws. Fix securely with assembly screws (4 screws) B x 4 pcs. Bracket Protrusion of Neck (top) Attach the cover and fix securely with assembly screw. A x 1 pcs. Cover ¦Set-up Tighten assembly screws (for 50”)/ (for 55”/60”/65”) (total 4 screws) loosely at first, then tighten them firmly to fix securely. B A x 4 pcs. (for 50”) x 4 pcs. (for 55”/60”/65”) Arrow mark (Image) Rear side Hole for pedestal installation Bracket Base Work on a flat surface Removing the pedestal from the TV Be sure to remove the pedestal in the following way when using the wall-hanging bracket or repacking the TV. Remove the assembly screws (for 50”)/ (for 55”/60”/65”) from the TV. Lift the TV from the pedestal. Remove the assembly screw from the cover. Pull out the cover. Remove the assembly screws from the Bracket. Remove the assembly screws from the Back of stand and pull out the neck. Warning Do not disassemble or modify the pedestal. Otherwise, the TV may fall over and become damaged, and personal injury may result. Caution Do not use any pedestal other than that provided with this TV. Otherwise, the TV may fall over and become damaged, and personal injury may result. Do not use the pedestal if it becomes warped or physically damaged. If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately. During set-up, make sure that all screws are securely tightened. If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong enough to support the TV, and it might fall over and become damaged, and personal injury may result. When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above) Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result. Location Location Adjust the plasma panel to your (View from above) .TC-P50ST50 desired angle. a: 9.1 ” (231 mm) c b: 18.2 ” (460 mm)Center of the c: 10° a rotation. c b Note .Ensure that the pedestal does not hang over the edge of the base even if the TV swivels to the full rotation range. .Do not place any objects or hands within the full rotation range. Power cord connection To attach To remove Insert it firmly until the tabs on both sides click into place. Keep pushing both sides until they snap and pull. Installing the remote’s batteries Pull open Hook Note the correct polarity (+ or -). Close Caution Incorrect installation may cause battery leakage and corrosion, resulting in damage to the remote control.• Do not mix old and new batteries.• Do not mix different battery types (such as alkaline and manganese batteries). • Do not use rechargeable (Ni-Cd) batteries. Do not burn or break batteries. Connections Connection Panels SD card slot Back of the TV USB1/2 terminal Ethernet connector .For , , connections, please refer to p. 12 Antenna or Cable connection Back of the TV Power Cord (Connect after all the other connections have been made.) Cable TV VHF/UHF Antenna or VHF/UHF Antenna • NTSC (National Television System Committee): ATSC (Advanced Television Systems Committee): Digital TV Standards include digital high-definition television (HDTV), standard-definition television (SDTV), data broadcasting, multi-channel surround sound audio and interactive television. Cable .You need to subscribe to a cable TV service to enjoy viewing their programming. .You may need to subscribe to a high-definition (HD) cable service to enjoy HD programming. The connection for high-definition can be done with the use of an HDMI or Component Video cable. (p. 12) Note .When using a Cable box, external equipment and video cables shown in this manual are not supplied with the TV. .When disconnecting the power cord, be absolutely sure to disconnect the power cord plug from the wall outlet first. .For additional assistance, visit us at: AV cable connection AV cable connection To use HDMI terminals Best Good Basic (Not HD) L R HDMI AV OUT HDMI-DVI Conversion cable DVI OUT AUDIO OUTComponent/AV adapter (not in use) white white red red AV Equipment e.g. Blu-ray Discplayer AV Equipment e.g. Blu-ray Discplayer white red red blue green/ yellow Component/AV adapter To use COMPONENT terminals L R Y PB PR AUDIO OUT COMPONENT VIDEO OUT whitewhite red green blue red green redred red blue white red blue green To use COMPOSITE terminals Component/AV adapter white green/ yellow (not in use) yellow white red red L R COMPOSITE OUT yellow white red yellow white red Note AV Equipment e.g. Blu-ray Discplayer AV Equipment e.g. DVD Recorder or e.g...
Эта инструкция также подходит к моделям:Телевизоры - TCP55ST50 (2.16 mb)
Телевизоры - TCP60ST50 (2.16 mb)
Телевизоры - TCP65ST50 (2.16 mb)