Оценок - 4, средний балл: 3.8 ( )

Производитель: American Dryer Corp. Размер: 475.08 kb Название файла: 216840en.pdf Язык инструкции:

The rating plate is located inside the door. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1362) fuse must be used. Should the plug need to be replaced for any reason. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow : Earth Blue : Neutral Brown : Live Blue Green & Yellow Brown Cord Clamp Electrical Connection • The wire coloured green and yellow must be connected to the terminal marked with the letter “E“ or by the earth symbol or coloured green and yellow • The wire coloured blue must be connected to the terminal “N“ or coloured black. • The wire coloured brown must be connected to the terminal marked “L“ or coloured red. • Upon completion there must not be cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. 1 WARNING: A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut off plug is disposed of safely. Permanent connection In the case of a permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3 mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations. The switch must not break the yellow and green earth cable at any point. Site Preparation Site Preparation • The installation surface must be clean and dry. • Do not install on a deep pile carpet. • If the appliance is installed next to a heat source (e. g. cooking appliance), a heat insulation pad (85 x 57 cm) must be placed between the washing machine and the heat source. • Do not install the appliance where the temperature may fall below freezing or rise above 35°C. • Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Levelling the Appliance The appliance must be levelled using the adjustable feet. Use a screwdriver to adjust to the feet until the appliance is level. Venting Venting The appliance expels hot, moist air which must be able to flow freely from the tumble dryer vent. Tumble Dryer Vents View from left Rear view View from right The most efficient way of venting the expelled air is via a vent hose through to the outside. Venting Venting through a Vent Hose The vent hose expelling the hot air should be 100 mm diameter and no longer than 4 meters. Avoid bends in the vent hose as this will reduce the air flow. The maximum length of the vent hose may be: 4 meters with 0 bends, or 2 meters with 2 bends. If the vent hose is to be permanently installed to the outside, a wall box or suitable cover should be used on the outside wall. Example: A vent hose (Part number: 647 000 010) and wall box (Part number: 647 000 020) are available from your local AEG Service Force Centre. Ensure the vent hose is not squashed. The drying efficiency of the tumble dryer will be affected and may cause the safety cut outs to operate. 1 Warning! The vent hose must not be connected to a flue pipe or chimney designed to carry the exhaust from a fuel burning heating appliance. Venting Venting without a Vent Hose If a vent hose is not connected to the tumble dryer, the air can be expelled into the installation room providing the following precautions are observed. • The vent(s) in use must be at least 30 cm from the wall or any other object. • Any vent less than 30 cm from a wall or other object must be closed using the cover provided. • The installation room must be well ventilated during the drying cycle. General Information 3General Information • To prevent creasing do not exceed the maximum load stated in the program table. • When using fabric conditioning sheets, we recommend the conditioning sheet is pinned (using a safety pin) to an article of laundry and placed in the tumble dryer. • When using fabric conditioning sheets or drying starched washing in the tumble dryer, it is important to clean the drum to prevent a build up of any residues/deposits. See maintenance and cleaning section. • Please ensure the appliance is easily accessible to an engineer after installation. 2Disposal Packaging • Dispose of the packaging material correctly. All packaging materials are environmentally friendly and can be disposed of without any danger to the environment. • The external plastic covering and bags inside are made of Polyethylen (marking >PE<). • The padding is made of CFC free expanded polystyrene (marking >PS<). Tumble Dryer When disposing of the tumble dryer. • Cut off the mains cable and destroy the plug. • Disable the door catch to prevent young children becoming trapped inside. • Use an authorised disposal site. Environmental protection tips 2 Environmental protection tips • Your laundry will become light and soft in the tumble dryer even without a fabric softening agent. • Loosen your laundry before load...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: