Оценок - 4, средний балл: 4.8
(
)
)
|
Фрагмент инструкции
Openings must be equally divided at the top and bottom of the door and airflow must be unobstructed. A louvered door with equivalent air openings for the length of the door is acceptable. 10 English LOCATION OF YOUR DRYER IN A CLOSET OR RECESSED AREA Following are instructions concerning and the minimum clearances required for any closet, recessed area, or customized under-counter installation: • Additional distances facilitate installation and servicing. • Addtional clearances might be required for wall, door and floor moldings. • Additional distances of 1 in. (25.4mm) on all sides of the dryer is recommended to reduce noise transfer. • For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. Companion appliance spacing should be considered. < 1 >k (25.4mm) 32. 5" (825mm) A ( 76mm) 11 English MANUFACTURED (MOBILE) HOME INSTALLATION 1. Dryer MUST be exhausted outside (outdoors, not beneath the manufactured home) using metal ducting that will not support combustion. Metal ducting must be 4 inch (10.16 cm) in diameter with no obstructions. Rigid metal duct is preferred. 2. If dryer is exhausted through the floor and area beneath the manufactured home is enclosed, the exhaust system MUST terminate outside the enclosure with the termination securely fastened to the mobile home structure. 3. When installing a gas dryer into a manufactured home, a provision must be made for outside make up air. This provision is to be not less than twice the area of the dryer exhaust outlet. 4. This dryer MUST be fastened to the floor using P/N 0030807988 Manufactured Home Installation Kit. Follow the instructions supplied with the kit. 5. Refer to previous sections for other important venting requirements. 6. I nstallation must conform to current Manufactured Home Construction & Safety Standard (which is a Federal Regulation Title 24 CFR-Part 32-80) or when such standard is not applicable, with American National Standard for Mobile Homes. In Canada, the CSA Z240 is applicable. D Sr Coffect (nooned Coffect InCOn^ Cl DON'T Inoofred 12 English CHANGING THE DRUM LIGHT 1. For your safety, please unplug the power cord before changing the drum light. 2. Open the dryer door, find the location of the drum light. Using a phillip head screw driver remove the light cover (as shown below). 3. Remove the bulb by turning it counterclockwise. Replace the bulb with a 15-watt lamp only, then install the cover and tighten the screw. 4. Use your dryer after plugging it in the electrical socket. 13 English ELECTRICAL INSTALLATION WARNING The following are specific requirements for proper and safe electrical installation of your dryer. Failure to follow these instructions can create electrical shock and/or fire hazard. ELECTRIC Dryer (CHDE/HDE5000AW and CHDE/HDE5300AW) GROUNDING INSTRUCTIONS This appliance must be ground...
Эта инструкция также подходит к моделям:Сушильные машины - CHDE5000AW (3.01 mb)
Сушильные машины - CHDE5300AW (3.01 mb)
Сушильные машины - HDE5000AW (3.01 mb)
Сушильные машины - CHDE5000AW (3.01 mb)