Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
26.The final part of a tumble dryer cycle occurs without heaat(cool down cycle)to ensure that the items are left at a temperature that ensures that the items will not be damaged. WARNING:Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. 3 4 5 Dimensions a = 855 mm b = 620 mm c = 595 mm Weight = 43 kg Packing accessories Checklist of the accessories and materials provided with the machine: Quantity To ensure the dryer operates normally, attention must be paid to the following instructions; ¦ The dryer must be level when installed. Its bottom is equipped with adjustable feet. Adjust these 4 feets to level the unit before operation; ¦ Check whether there is any damage to the dryer during transportation. Any damaged dryer must not be used. if the unit is damaged, contact your dryer supplier; ¦ The dryer must be kept away from flammable substances; ¦ The surrounding environment must be dry and ventilated; ¦ To allow the dryer to perform better, the ambient temperature shall not be lower than 10. nor higher than 35.. Change the door-opening direction If the direction of the dryer's door is not suitable to the location, its opening direction may be changed. The procedure is as follows: 1. Unscrew the 4 hinge screws holding the door onto the machine and remove the door. 2. Unscrew the door catch 6 and prise out the catch cover on the opposite side of the door and transpose them. 3. Unscrew the door hinges and prise out the hinge covers on the opposite side of the door and transpose them. 4. Remove the 4 blanking plugs from the screw holes on the machine and insert them in the holes on the other side. 5. Refit the door on the opposite side of the machine. a-door hinge b-catch cover c-door d-hinge cover e-door catch f-blanking plug Name Owner's manual Certificate of Conformity Drainpipe Installtion Installtion b c c d e b a e f Preparation Installtion 6 be removed from the box after every drying cycle. If your dryer is in the vicinity of a drain, you may allow the condensed water to discharge directly into the drain through the drainpipe provided to avoid emptying the box every time. The method to connect the drainpipe is as follows: 1. Loosen the hose clip with the drain switchover joint; 2. Pull the hose off the joint; 3. Install the accessory drainpipe on the joint; 4. Fix the hose in place with the clip; Note: The outlet of the drainpipe must not be higher than 1.0 m above the floor 7 Turning on power Before turning on the power for the dryer, check: ¦Whether the supply voltage is in accordance with the value indicated on the nameplate; Whether the supply receptacle can withstand the maximum power load to the dryer; Whether the supply receptacle is in accordance with the plug of the dryer. If not, replace the power supply cable or receptacle to make them accord with each other; The replacement of the power supply cable must be made by a qualified professional...
Эта инструкция также подходит к моделям:Сушильные машины - HDY-D70-F (2.65 mb)
Сушильные машины - HDY-D70-F (2.65 mb)
Сушильные машины - HDY-D70-F (2.65 mb)
Сушильные машины - HDY-D70-F (2.65 mb)