Оценок - 3, средний балл: 4.3 ( )

Производитель: Harbor Freight Tools Размер: 631.85 kb Название файла: Язык инструкции:

1. Disconnect tool from air hose, empty Magazine A (66) of staples, release any built-up air pressure, and leave the magazine open, as explained above. 2. Safety Cover Bolt (53)FIGURE 1While doing this step and the next, hold the Stapler pointed away from you and any other people or fragile objects - see Figure 1. Remove all three Safety Cover Bolts (53) on the Safety Cover (54). 3. FIGURE 2Safety (52) Safety Cover (54) Lift the Safety Cover (54) off the top of the stapler - see Figure 2. 4. FIGURE 3Driver (19) Driver Cover (57) Carefully slide the Driver Cover (57) off around the Safety (52) and remove the jammed staple - see Figure 3. Use pliers to remove a stuck staple. 5. Inspect the Driver (19) for bends or breakage - see Figure 3. If it is damaged, do not use the tool until it is repaired by a qualified technician. 6. Lightly oil the Driver (19) and replace the Driver Cover (57). Replace the Safety Cover (54), being careful to line up the bolt holes and fit the Safety (52) into the slot. Replace and securely tighten all of the Safety Cover Bolts (53). The Safety (52) must move without sticking. 7. Reload the Stapler. 8. Reconnect the Stapler to the air hose. 9. Press the Safety (52) of the Stapler against an appropriate piece of scrap wood and test fire the Stapler several times, checking for proper operation. 10. Disconnect the Stapler, remove the staples, and store the Stapler in a location out of children’s reach. MAINTENANCE TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE ANY MAINTENANCE OR REPAIRS ARE DONE (including clearing jams): • Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear ANSI-approved impact safety goggles with side shields. • Release the trigger. • Detach the air supply. • Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners. • Empty the magazine and leave it open during service. Note: If the Stapler leaks air, continually skips staples, does not drive the staple properly, or the Trigger (39) or Safety (52) do not move freely have it serviced by a qualified service technician. 1. After each use, check the tightness on all visible screws. 2. Wipe the Stapler clean daily with a damp cloth and non-flammable cleaning solution. Never soak the Stapler. 3. Make sure that no dirt or debris blocks the fastener discharge area. 4. Any maintenance, service, or repairs, apart from those procedures explained in this manual, are to be attempted only by a qualified technician. REV 10a PARTS LIST Part Description 1 Exhaust Deflector 2 O-Ring 3 Hex. Bolt 4 Head Cap 5 Seal 6 Internal Lining 7 O-Ring 8 Compression Spring 9 Gasket 10 O-Ring 11 Head Valve Piston 12 O-Ring 13 O-Ring 14 O-Ring 15 Collar 16 O-Ring 17 Piston 18 Pin 19 Driver 20 O-Ring 21 Lining Ring 22 O-Ring 23 Cylinder 24 O-Ring 25 Bumper 26 Body 27 Nozzle 28 Seal Part Description 29 Trigger Valve Upper ...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: